Abstract:As the high critical current at high field, the representative second-generation high-temperature superconductor (2G HTS) REBCO-coated conductor serves as a good candidate for the future China Fusion Engineering Test Reactor (CFETR) with a magnet field exceeding 15 T. The Institute of Plasma Physics, Chinese Academy of Sciences (ASIPP) is engaged in the R D activities of REBCO-based HTS Twisted Stack Slotted-core Cables (TSSC) with the objective of validating the feasibility of cable-in-conduit conductor (CICC). Two 1.3-m-long TSSC samples, each comprising 32 3-mm-wide REBCO-coated conductors and 56 copper tapes, have been manufactured and successfully tested at 77 K and self-field, followed by a joint resistance test at 4.2 K. The critical current of the both TSSC specimens at 77 K was tested to be 2830–2886 A with an n-value of approximately 30, which is similar to the simulation value, demonstrating no significant degradation occurred during fabrication. Nevertheless, current transfer between cables is carried out through joints, and the manufacturing process of the joint terminals can seriously affect the capability to achieve current transfer with a low resistance. Therefore, an oil-bath heated melting solder method was presented to prepare the joint terminals for HTS TSSC cables, as well as resistance measurements being evaluated. At 77 K, the terminal resistance was measured to be in the tens of nano-ohms, in comparison to about 0.68 nΩ at 4.2 K. The findings of this study offer valuable insight into the conductor preparation process and provide a foundation for future developments in large-scale fusion magnet applications.

Superconducting Transformer for Superconducting Cable Testing up to 45 kA

Test Facility for Critical Current Measurement of Superconducting Conductors

Calibration of a superconducting transformer by measuring critical current of a NbTi Rutherford cable

Test Station for High Temperature Superconducting Power Cables

Design and Performance Tests of a Fault Current-Limiting-Type Tri-Axial HTS Cable Prototype

Development of a Conduction-Cooled HTS SMES

Analysis of Thermo-electric Coupled Simulation for 10 Kv AC XLPE Cable under Different DC Topologies and Laying Modes

Development of a cryogenic DC transformer using for the measurement of large current

Dynamic Experiment For The Magnetothermal Stability Of A 110 Kv/3 Ka Cold Dielectric High-Temperature Superconducting Cable With An Impact Of Fault Current In Power System

Critical Current Measurement of REBCO Cables by Using a Superconducting Transformer

Performance of the Cable-in-Conduit Conductors for Super-X Test Facility

The Superconducting Transformer of the Samsung Superconductor Test Facility (Sstf)

Design and Development of 16-Ka HTS Current Lead for HMFL 45-T Magnet

A Novel AC Loss Measurement Technology for High Temperature Superconducting Cable With Large Current Capacity Using a Compensation Coil

Manufacture and Test of Bi-2212 Cable-In-Conduit Conductor

Experimental Studies of Critical Currents and Joint Resistance of HTS Twisted Stack Slotted-Core Cables

Dc Superconducting Cable Using Mgb2 Wires

Experimental Investigation Of A High Temperature Superconducting Pancake Consisted Of The Rebco Composite Cable For Superconducting Magnetic Energy Storage System

Design Study on a 100-Ka/20-k HTS Cable for Fusion Magnets

10 Kv AC Test Verification of the High Temperature Superconducting Fault Current Limiter with Bias Magnetic Field

RETRACTED: Development of a Cryogenic Test Bed for High Amperage Critical Current Measurement on High Temperature Superconductor Wire