Abstract:Neutronics calculations and analysis' of ITER test blanket module lay the foundation for the design, construct and experiment of ITER. In this paper, the realistic 3D neutronics calculations of the dual functional lithium lead-test blanket module (DFLL-TBM) have been carried out by means of the 3D MOC code and the SPN code, which are both deterministic methods and developed by NECP lab, adopting the multi-group nuclear data library FENDL/MG-2.1. The main features of the TBM nuclear response are assessed, paying a particular attention to the neutron flux and tritium production rate.The 3DMOC code([8]) is a coupling a 3D method of characteristics (MOC) to the common geometry module. It could calculate the flux throughout three-dimensional systems by the MOC, which has been proved a very flexible and effective method for the neutron transport calculation in a complex geometry. In this code, a modular ray tracing technique is adopted to reduce the amount of the ray tracing data and the Coarse Mesh Finite Difference (CMFD) acceleration method is employed to save computing time, which could well solve the difficulties when applying MOC in three-dimensional geometries([1]).The SPN code is another three-dimensional Boltzmann transport equation calculation code. The simplified P-N method is used to treat the directional variable, and the Nodal method treats the spatial variable. Consequently, this code has an advantage in shorting computing time when applied to big geometry problems.Considering the big geometry of DFLL-TBM and the large number of the cross sections of nuclear data library FENDL/MG-2.1([2]), a two-step approach is adopted Firstly, the DFLL-TBM is dissected into some typical independent parts. 3D calculations are performed on these parts respectively with 3D MOC code and FENDL/MG-2.1([2]) library to obtain the detailed heterogeneous flux distribution. Then the homogenization is carried out to calculate the average homogeneous cross sections, followed by the use of homogeneous cross sections to calculate the flux distribution throughout the DFLL-TBM with SPN code.The results obtained are herewith presented and critically discussed

Nuclear analysis for the Test Cell Lithium System Interface Cell during operation and shutdown

Neutronic analysis of IFMIF-DONES test cell cooling system

Nuclear analysis and shielding optimisation in support of the ITER In-Vessel Viewing System design

Preliminary Safety Analysis For The Chinese Iter Dual Functional Lithium-Lead Test Blanket Module

Neutronic Analysis of Ifmif High Flux Test Module for High Temperature Irradiation

Activation analysis for ITER shielding blanket

Nuclear analyses for the integration of ITER equatorial Port 2

Updates of the removable biological shielding blocks inside of the test cell, part of the test systems of IFMIF-DONES

Monitoring for Actinide Neutron Emissions From Spent Nuclear Fuel Under Extreme Gamma Fields Using Centrifugally Tensioned Metastable Fluid Detector Sensor Technology

Safety Analysis on Dual-functional Lithium Lead Test Blanket Module With RELAP5

Shielding analysis for ITER equatorial bio-shield plug

Neutron and Gamma-Ray Transport Calculations in Support of the Design of the Radiation Shielding for the TOFED Neutron Spectrometer at LHD

Calculations Of The Dual Functional Lithium Lead-Test Blanket Module For Iter With Three-Dimensional Deterministic Method

Neutronics Analysis of the ITER In-Vessel Viewing System

Nuclear analyses for the ITER Diagnostic Equatorial Port 8

Shielding optimization to reduce the radiation field in the accelerator systems of IFMIF-DONES

Neutronics Analysis of the Upper Port for ITER

Primary Shielding Design and Analysis for Clear-I

Shielding design of the ITER NBI duct for nuclear and bremsstrahlung radiation

Neutronic calculations of the China dual-functional lithium–lead test blanket module with the parallel discrete ordinates code Hydra

Analysis of Radiation Conditions in the CFETR Ion Cyclotron Resonance Heating Antenna