Abstract:Radiation safety standards today require comprehensive shielding protection schemes for all particle accelerators. The original shielding system of BJ-20 (BeiJing-20 MeV), the high-energy medical electron linac, was designed only for the 18 MeV level. And the dose caused by the lost electrons in the 270° bending magnet system was neglected. In this paper, the leakage dose of BJ-20 is carefully analyzed. The radiation leakage dose distribution of the photons coming from the accelerator head is obtained for energy levels of 6, 12, 14, and 18 MeV. The dose of the photoneutrons is especially analyzed for the 18 MeV level. The result gives that even neglecting the dose from the 270° bending magnet system, the shielding system is still not enough for the energy levels lower than 18 MeV. The radiation leakage produced by electrons that are lost in the 270° bending magnet system has been particularly studied. Using beam transport theory and Monte Carlo sampling methods, which have been combined in calculations, we have obtained the distribution of the energy, position, and direction of the lost electrons. These data were then further processed by the Monte Carlo N-particle (MCNP) code as input data. The results show that when the electron loss rate in the 270° bending magnet system is 13.5%, the radiation leakage dose of the photons generated by the lost electrons is 0.1% higher than that at the isocenter, and the corresponding relative leakage dose of the photoneutrons reaches 0.045% around an angle of 170° at 18 MeV level. Both of these parameters exceed radioprotection safety standards for medical accelerators. The original shielding design is therefore not suitable and is also incomplete since the radiation produced by the electrons being lost in the 270° bending magnet system was neglected and the leakage dose for the low-energy levels was not considered in the original design. Our calculations provide a very useful tool for further optimization and design improvement that will enable this radiation shielding to conform to present day safety standards.

Monte Carlo Calculation of Induced Radioactivity for a 15-MV Electron Accelerator Head Structure

MCNP simulation of X-ray beam for a 15 MV medical linear accelerator

Study on Induced Radioactivity in Proton Therapy Accelerators

Simulation of Induced Radioactivity for A Heavy Ion Medical Machine

Simulation of induced radioactivity for Heavy Ion Medical Machine

Evaluating activation of the shielding walls of a treatment room using the Monte Carlo method

Calculating method for induced radioactivity in an electron linear accelerators

Calculating method for induced radioactivity in an electron linac

Monte Carlo Calculation of the Shielding of Mail Irradiation Systems

Monte Carlo method for analyzing research reactor shielding

Activation analysis for ITER shielding blanket

The Monte Carlo Simulation of Tsinghua Homo-Source Dual-Beam Medical Accelerator

Shielding Research of Minitype Reference Radiation Device Based on Monte Carlo Simulation

Monte Carlo method for calculating the radiation skyshine produced by electron accelerators

Physical Analysis of the Radiation Shielding for the Medical Accelerators

Radiation transport calculations for the European Spallation Source accelerator environment

Study on the Radiation Problem Caused by Electron Beam Loss in Accelerator Tubes

Structural Shielding Design of CT Facility using Monte Carlo Simulation

Optimalizing electron beam parameters of linear accelerator based on Monte Carlo simulation

Induced radioactivity analysis for the NSRL Linac in China using Monte Carlo simulations and gamma-spectroscopy

Dose Equivalent of Neutron and Induced Gamma Rays Near a Medical Accelerator