Abstract:A detailed assessment of the thermo-mechanical limits of the ITER divertor with respect to potential excessive local transient heat loads due to Edge Localised Modes (ELMs) has revealed a particular power loading scenario arising from the fact that ELM ions expelled from the upstream pedestal region will arrive at the divertor target plates without substantial thermalisation. As a consequence of their Larmor gyration around magnetic field lines, they are able to penetrate toroidal gaps between individual monoblocks of the target plate structure and can deliver rather intense heat loads to monoblock side faces near the gap entrance. To verify that this ELM-induced loading, predicted by both ion orbit simulations and particle in cell simulations, really does occur, two dedicated experiments have been performed on the ASDEX Upgrade tokamak. In both experiments a model toroidal gap structure of similar dimensions to those of the ITER divertor target monoblocks was exposed to a series of identical H-mode discharges with strong type-I ELMs. The effects arising from the gyro motion of hot ELM ions were identified by inverting, in the second experiment, the directions of both toroidal field and plasma current, thus reversing the ion gyration direction. The local distribution of incident ion flux on the gap side faces was quantified by pre- and post-exposure analysis of platinum marker layers to determine quantitatively the erosion rate of the platinum marker. The results fully confirm the ion orbit code predictions with respect to the penetration depth of incident ions with gyro orbits of similar or larger radius than the gap width. Moreover, the results confirm that ELM ions do indeed arrive at the divertor with their typical pedestal energies and also allow conclusions to be drawn regarding the corresponding intra-ELM ion particle and power flux, which is not easy to quantify using Langmuir probes.

Nuclear analyses for the ITER Diagnostic Equatorial Port 8

Nuclear analyses for the integration of ITER equatorial Port 2

Radiation environment in ITER tokamak equatorial port 11

Numerical Analyses of Electromagnetic Forces on the ITER Blanket Module Shield Block During Major Disruptions

Nuclear analysis and shielding optimisation in support of the ITER In-Vessel Viewing System design

Neutronics Analysis of the ITER In-Vessel Viewing System

Neutronics Analysis of the Upper Port for ITER

Numerical analysis on neutron shielding structure of ITER vacuum vessel

Survey and Test Environment for ITER EPP#12 Electrical Components

Neutronic Analyses of Port Impact on Blankets and Superconducting Coils of CFETR

Neutronic analysis of IFMIF-DONES test cell cooling system

First principle-based multi-channel integrated modelling in support of the design of the Divertor Tokamak Test facility

Impact of nuclear heating distribution on the structural behavior of ITER first wall panel 11

Preliminary CFD and EM Analysis of the ECRH Equatorial Launcher Port Plug Prototype Towards the CFETR

The In-situ Neutronics Calculation of NFM in the ITER

Cooling Circuit Development of Equatorial Diagnostic Port Plug Dedicated to International Thermonuclear Experimental Reactor

Assessment of ITER radiation environment during the remote-handling operation of In-Vessel components with D1SUNED

Electromagnetic analysis on conceptual design of the EU DEMO EC equatorial laucher

Investigation of ELM-related Larmor ion flux into toroidal gaps of divertor target plates

Evaluation of electromagnetic forces on Chinese Dual Functional Lithium Lead Test Blanket Module in ITER

Shielding analysis for ITER equatorial bio-shield plug