Abstract:The residual stress in low-alloy hot-rolled strips seriously affects the use and processing of products. Reducing residual stress is important for improving the product quality of hot-rolled strips. In this paper, the changes in grain size and residual stress of hot-rolled strips under different cooling processes were investigated via thermal simulation experiments and electron backscatter diffraction. It was found that the optimum cooling process solution for single-objective optimization of grain size was a final rolling temperature of 875 °C, a laminar cooling speed of 50 °C/s, and a coiling temperature of 550 °C. When single-objective optimization of residual stress was carried out, the optimal cooling process scheme was 900 °C for final rolling temperature, 20 °C/s for laminar cooling speed, and 625 °C for coiling temperature. The significance of the effect of cooling processes on grain size and residual stress was analyzed based on the extreme deviation of the effect of each cooling process on grain size and residual stress in orthogonal experiments. The results show that the coiling temperature was the most influential factor on grain size and residual stress among the cooling process parameters. The difference was that grain size increased with increasing coiling temperature, and residual stress decreased with increasing coiling temperature. Using both grain size and residual stress as evaluation indicators, a multi-objective optimization of the cooling process for hot-rolled strips was carried out via the gray correlation analysis method. The optimized solution was 875 °C final rolling temperature, 30 °C/s laminar cooling speed, and 625 °C coiling temperature. At this time, the grain size was 4.8 μm, and the KAM (Kernel Average Misorientation) was 0.40°. The grain size under the actual production process scheme was 4.4 μm with a KAM of 0.78°. Compared to the actual production process solution, the multi-objective optimization solution showed little change in grain size, with only a 9% increase and a 49% reduction in KAM. The optimization scheme in this paper could significantly reduce the level of residual stresses while ensuring the fine grain size of hot-rolled strips, thus improving the overall quality of hot-rolled strips.

Study on the effect law of jet angle on the cooling of hot-rolled L-beam

Influence of jet angle on heat transfer during cooling of hot rolled seamless steel tubes

Thermo-Mechanical Coupling Computation and Warping Analysis During Controlled-Cooling of X65 Heavy Pipeline-Plate

Latent heat and TRIP effect of X65 heavy pipeline plate during controlled cooling

Numerical simulation of single-jet impact cooling and double-jet impact cooling of hot-rolled L-shaped steel based on multiphase flow model

The effect of laminar cooling heat transfer coefficient on the temperature field of steel plate

Experimental and Numerical Investigations on Double-Jet Film-Cooling with Different Mainstream Incidence Angles

Effect of liquid nitrogen jet impingement angle on machinability of titanium alloy in cryogenic cooling

Online Partition-Cooling System of Hot-Rolled Electrical Steel for Thermal Roll Profile and Its Industrial Application

Numerical Study on the Near-Wall Characteristics of Compound Angled Film Cooling Based on Hybrid Thermal Lattice Boltzmann Method

The Effects of Geometry Parameters on the Cooling in Performance and Aerodynamic Characteristics of Lamilloy

Numerical investigation of flow field and heat transfer characteristics in a latticework duct with jet cooling structures

Simulation on the spray cooling of a high-temperature cylindrical surface

Experimental Study on Heat Transfer Characteristics of LBE Flow in a Vertical Tube under Static and Rolling Conditions

Multi-Objective Optimization of Low-Alloy Hot-Rolled Strip Cooling Process Based on Gray Correlation Analysis

Experimental research on flat plate film cooling effectiveness at different injection angles

Heat Transfer from a Hot Steel Plate Impinged by Air-atomized Water Jet and Impinging Water Jet

Numerical simulation and experimental study of strip steel jet cooling

Effects Of Curvature On The Film Cooling Effectiveness Of Double-Jet Film Cooling

Flow and heat transfer analysis of lead-bismuth eutectic flowing in a tube under rolling conditions

Study on the External Cooling Mechanism of Aluminium's High-speed Cast-rolling Process