Experimental research on flat plate film cooling effectiveness at different injection angles

Jie Liu,HAN Zhen-Xing,LIU Jian-Jun,JIANG Hong-De,ZHOU Si-Jing
2007-01-01
Kung Cheng Je Wu Li Hsueh Pao/Journal of Engineering Thermophysics
Abstract:This paper describes the current studies on the film cooling effectiveness of single-row holes in flat plate at different injection angles, including 30°, 60° and 90°. The distributions of adiabatic film cooling effectiveness downstream the film holes at three blowing ratios of 0.5, 1.0 and 1.5 are analyzed, respectively. According to the experimental results, good cooling effectiveness in the region near the film holes for the three injection angles is achieved at a blowing ratio M=0.5. The lateral averaged cooling effectiveness downstream the cooling holes for the three injection angles is approximately identical at the blowing ratio M=1.0. The cooling effectiveness with injection angle of 60° is the best among the three injection angles at the blowing ratio M=1.5.
What problem does this paper attempt to address?