Abstract:A dual-tip conductivity probe was used to measure local radial gas holdups and bubble chord lengths to study the local flow regime and bubble size distribution in a scrubbing-cooling chamber cold model apparatus containing slender particles. The results showed that the cross-section averaging gas holdups with different fiber volume fractions and aspect ratios could be estimated within errors of +/- 10% using the modified Kataoka-Ishii bubbly flow semi-empirical correlation at superficial gas velocities ranging from 0.074 m/s to 0.37 m/s. The local flow regime map showed that an obvious bubbly flow formed near the inner wall of the liquid bath due to the effect of wall shear stress, while a cap-bubbly flow formed in other annulus regions due to the emergence of cap bubbles. Chord length distributions were transformed into bubble size distributions by decomposing the measured chord length distributions and estimating the bubble shape factors. Bubble size was categorized into two types-small spherical and large nonspherical bubbles-depending on if the equivalent diameter of the bubbles was smaller or larger than 2 mm. Liquid turbulence, shear stress between the fluid and the wall and liquid backmixing were enhanced by increasing the superficial gas velocity, which affected the size distributions of rising and descending bubbles as well as that of bubble populations. The extent of turbulence suppression and "fiber separation walls" varied with the fiber volume fractions, which affected the bubble size distribution in different regions. The fiber number density characterizing the variation of the fiber aspect ratio with different fiber diameter and length was used to study the bubble size distribution. The bubble size distribution at different aspect ratios was affected by interactions among fibers, bubbles, the fluid and the wall. (C) 2018 Elsevier Ltd. All rights reserved.

Fluctuation analysis and spatial distribution model of particle concentration in a lab-scale scrubbing-cooling chamber

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Numerical simulation of pressure fluctuation in gas-solids agitated fluidized bed

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Experimental and Modeling Investigation of Liquid-Induced Agglomeration in a Gas–Solid Fluidized Bed with Liquid Spray

CFD Simulation and Experiments of Dynamic Parameters in Gas–solid Fluidized Bed

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Multi-scale Characteristics and Gas-Solid Interaction among Multiple Beds in a Dual Circulating Fluidized Bed Reactor System

Investigation On The Ash Deposition Of A Radiant Syngas Cooler Using Critical Velocity Model

Characterization of Flow Pattern of Cohesive Particles in Gas-Solid Fluidized Bed Via Axial Distribution of Particle Motions

Evolution and Fluidization Behaviors of Wet Agglomerates Based on Formation-Fragmentation Competition Mechanism

Local Distributions of Bubble Velocity and Interfacial Area in the Slender Particle-Containing Scrubbing–Cooling Chamber of an Entrained-Flow Gasifier

Radial distribution of solid holdup and its fluctuation characteristics in a three-phase scrubbing-cooling chamber

Gas Distribution Characteristics for Heterogeneous Flows in the Slender Particle-Containing Scrubbing–cooling Chamber of an Entrained-Flow Gasifier

Local Flow Regime and Bubble Size Distribution in the Slender Particle-Containing Scrubbing-Cooling Chamber of an Entrained-Flow Gasifier

Two-Fluid Model Simulations of the National Energy Technology Laboratory Bubbling Fluidized Bed Challenge Problem

Dynamic Characteristics of Solids Circulation Establishment in Laboratory and Industrial Circulating Fluidized Beds with Sweeping Bend Return

Influence of internal components on the hydrodynamic properties of the scrubbing-cooling chamber

STUDY ON INFLUENCE OF BUBBLE- BREAKING STRUCTURE UPON THE GAS BUBBLE PROPERTIES IN THE SCRUBBING CHAMBER

Eulerian-Lagrangian simulation study of the gas-solid reacting flow in a bubbling fluidized coal gasifier