Abstract:A dual-tip conductivity probe was used to measure local radial gas holdups and bubble chord lengths to study the local flow regime and bubble size distribution in a scrubbing-cooling chamber cold model apparatus containing slender particles. The results showed that the cross-section averaging gas holdups with different fiber volume fractions and aspect ratios could be estimated within errors of +/- 10% using the modified Kataoka-Ishii bubbly flow semi-empirical correlation at superficial gas velocities ranging from 0.074 m/s to 0.37 m/s. The local flow regime map showed that an obvious bubbly flow formed near the inner wall of the liquid bath due to the effect of wall shear stress, while a cap-bubbly flow formed in other annulus regions due to the emergence of cap bubbles. Chord length distributions were transformed into bubble size distributions by decomposing the measured chord length distributions and estimating the bubble shape factors. Bubble size was categorized into two types-small spherical and large nonspherical bubbles-depending on if the equivalent diameter of the bubbles was smaller or larger than 2 mm. Liquid turbulence, shear stress between the fluid and the wall and liquid backmixing were enhanced by increasing the superficial gas velocity, which affected the size distributions of rising and descending bubbles as well as that of bubble populations. The extent of turbulence suppression and "fiber separation walls" varied with the fiber volume fractions, which affected the bubble size distribution in different regions. The fiber number density characterizing the variation of the fiber aspect ratio with different fiber diameter and length was used to study the bubble size distribution. The bubble size distribution at different aspect ratios was affected by interactions among fibers, bubbles, the fluid and the wall. (C) 2018 Elsevier Ltd. All rights reserved.

Radial distribution of solid holdup and its fluctuation characteristics in a three-phase scrubbing-cooling chamber

Studies on hydrodynamics of slurry turbulent bubble column(Ⅰ) Gas holdup and its radial distribution

Study on bubble size distribution and local gas holdup in bubble column

Experimental and Numerical Simulation on Sequential Three Phase Jet-Loop Reactor

Experimental and Numerical Study of Solids Concentration Distribution in Transition Section of Turbulent Fluidized Bed

Study on Local Gas-Liquid Dispersion in Dual-Impeller Aerated Stirred Vessel

Experimental and Numerical Investigations of Scale-Up Effects on the Hydrodynamics of Slurry Bubble Columns

Experimental and numerical investigation of solid behavior in a gas–solid turbulent fluidized bed

Gas Holdup and Liquid Velocity Distribution in a Jet Loop Reactor

The Measurement of Local Gas Holdup under High Superficial Velocity in Bubble Column

Experimental Investigation on Solid Particle Distribution in Dense Solid–liquid Stirred Tank

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Fluctuation analysis and spatial distribution model of particle concentration in a lab-scale scrubbing-cooling chamber

Dynamic and Steady-State Characterization of the Liquid Spray Zone in an Externally Heated Gas–Solid Fluidized Bed

Local Distributions of Bubble Velocity and Interfacial Area in the Slender Particle-Containing Scrubbing–Cooling Chamber of an Entrained-Flow Gasifier

Local Flow Regime and Bubble Size Distribution in the Slender Particle-Containing Scrubbing-Cooling Chamber of an Entrained-Flow Gasifier

Influence of internal components on the hydrodynamic properties of the scrubbing-cooling chamber

Gas Distribution Characteristics for Heterogeneous Flows in the Slender Particle-Containing Scrubbing–cooling Chamber of an Entrained-Flow Gasifier

Experimental study of dynamic characteristics of solid holdup fluctuations in a gas-solid cyclone reactor

Investigation of Unstable Solids Circulation Behavior in A Circulating Fluidized Bed with Sweeping Bend Return Using Pressure Frequency Analysis

CFD simulation on shear-thinning gas-liquid dispersion in coaxial mixer