Abstract:A dual-tip conductivity probe was used to measure local radial gas holdups and bubble chord lengths to study the local flow regime and bubble size distribution in a scrubbing-cooling chamber cold model apparatus containing slender particles. The results showed that the cross-section averaging gas holdups with different fiber volume fractions and aspect ratios could be estimated within errors of +/- 10% using the modified Kataoka-Ishii bubbly flow semi-empirical correlation at superficial gas velocities ranging from 0.074 m/s to 0.37 m/s. The local flow regime map showed that an obvious bubbly flow formed near the inner wall of the liquid bath due to the effect of wall shear stress, while a cap-bubbly flow formed in other annulus regions due to the emergence of cap bubbles. Chord length distributions were transformed into bubble size distributions by decomposing the measured chord length distributions and estimating the bubble shape factors. Bubble size was categorized into two types-small spherical and large nonspherical bubbles-depending on if the equivalent diameter of the bubbles was smaller or larger than 2 mm. Liquid turbulence, shear stress between the fluid and the wall and liquid backmixing were enhanced by increasing the superficial gas velocity, which affected the size distributions of rising and descending bubbles as well as that of bubble populations. The extent of turbulence suppression and "fiber separation walls" varied with the fiber volume fractions, which affected the bubble size distribution in different regions. The fiber number density characterizing the variation of the fiber aspect ratio with different fiber diameter and length was used to study the bubble size distribution. The bubble size distribution at different aspect ratios was affected by interactions among fibers, bubbles, the fluid and the wall. (C) 2018 Elsevier Ltd. All rights reserved.

STUDY ON INFLUENCE OF BUBBLE- BREAKING STRUCTURE UPON THE GAS BUBBLE PROPERTIES IN THE SCRUBBING CHAMBER

Influence of internal components on the hydrodynamic properties of the scrubbing-cooling chamber

Modelling of Mass Transfer for Gas-Liquid Two-Phase Flow in Bubble Column Reactor with a Bubble Breakage Model Considering Bubble-Induced Turbulence

Bubble Size “bimodal” Distribution Enhances Mixing and Mass Transfer in Slurry Bubbling Column Reactor

Experimental Study and Numerical Simulation of Heat and Mass Transfer in Scrubbing-Cooling Pipe

Modeling and optimization of scrubbing process of coal-water slurry gasification plant

Local Distributions of Bubble Velocity and Interfacial Area in the Slender Particle-Containing Scrubbing–Cooling Chamber of an Entrained-Flow Gasifier

Local Flow Regime and Bubble Size Distribution in the Slender Particle-Containing Scrubbing-Cooling Chamber of an Entrained-Flow Gasifier

NUMERICAL SIMULATION ON TURBULENT FLOW AND HEAT TRANSFER OF VERTICAL PIPE IN QUENCH CHAMBER OF COAL GASIFIER

Fluctuation analysis and spatial distribution model of particle concentration in a lab-scale scrubbing-cooling chamber

Numerical Simulation of a Retrofitted Quench Chamber of a Coal Gasifier

CFD study of the thermochemical characteristics of mesoscale bubbles in a BFB gasifier

Gas Distribution Characteristics for Heterogeneous Flows in the Slender Particle-Containing Scrubbing–cooling Chamber of an Entrained-Flow Gasifier

Experimental Study on the Performance of Heat Transfer of A Novel Liquid-Gas Two-Phase Flow Scrubber for Flue Gas Desulfurization

Simulation of Heat and Mass Transfer in Pulverized Coal Boiler Based on Gaseous Combustion Through Phase Separation Technique

Eulerian-Lagrangian simulation study of the gas-solid reacting flow in a bubbling fluidized coal gasifier

Visualization Study on Breakup Modes of Coal Water Slurry in an Impinging Entrained-Flow Gasifier

A new gas-liquid mass transfer enhancement method for a multi-downcomer sieve tray: Bubble breakup by falling droplets

Numerical Modeling of a Bubbling Fluidized Bed Coal Gasifier by Kinetic Theory of Rough Spheres

Hydrodynamic performance and structural optimization of a slurry bubble column with vertical tube internals

Simulation and Exergy Analysis of Scrubbing-Cooling Chamber in Entrained-Flow Bed Gasification System