Abstract:The tempering process of plate glass involves rapidly cooling the high-temperature glass using an array of impinging air jets, inducing desired stress during cooling. Consequently, the formation of tempering stress results from the coupled interaction among flow, heat transfer, and stress. However, most previous studies have commonly neglected the influence of the flow field by assuming a uniform and constant distribution of heat transfer coefficients at different positions on the glass plate, which deviates from actual situations. This study employed a fluid-thermal-structural coupled simulation approach to predict the non-uniform residual stress distribution in tempered glass and investigate the interaction mechanisms among flow, heat transfer, and stress. Simultaneously, to validate the reliability of the method and model, this study experimentally investigated the single-nozzle jet impingement cooling for glass tempering. The study concluded that the simulation results were consistent with the experiment. Subsequently, a comparative analysis was performed between the fluid-thermal-structural coupled simulation results based on real boundary conditions and the thermal-structural coupled simulation results based on ideal uniform heat transfer coefficient boundary conditions. The results revealed non-uniform distributions of both heat transfer coefficient and temperature due to varying localized flow characteristics. Consequently, the ratio of surface compressive stress to internal tensile stress along the width direction of the glass was not a fixed value but ranged from 1.63 to 2.38. Furthermore, significant differences were observed in the stress distribution under the simulations of fluid-thermal-structural coupling and thermal-structural coupling. Therefore, it is recommended to employ the fluid-thermal-structural coupling method when predicting localized stress distribution.

Low-Temperature Gas Cooling Correction Trajectory Offset Technology of Laser-Induced Thermal Crack Propagation for Asymmetric Linear Cutting Glass

Semiconductor laser asymmetry cutting glass with laser induced thermal-crack propagation

Effect of thermal stresses on chip-free diode laser cutting of glass

Temperature Field Simulation and Experimental Analysis of Laser Cladding 45 Steel.

Laser cutting sandwich structure glass–silicon–glass wafer with laser induced thermal–crack propagation

The Research on the Edge Thermal Effect of the Thin Disk Crystal in Thin Disk Lasers

Pre-Compensation of Thermal Error for Laser-Assisted Diamond Turning

Simulation of laser brazing of sheet panels and parametric studies of thermally-induced distortion reduction

Numerical Analysis of the Temperature Field during Single-pass Two-layers Laser Additive Manufacturing of Fused Silica Glass

Research on a Compensation Correction Algorithm for the Removal Function of Atmospheric-Pressure Plasma Processing

Thermal stress analysis on laser scribing of glass

Tensile strength and crack tip stress distribution of modified glass in the composite laser beam separation

YAG laser cutting soda-lime glass with controlled fracture and volumetric heat absorption

Morphology evolution mechanisms and localized structural modification of repaired sites on fused silica optics processed by CO2 laser rapid ablation mitigation

Three-dimensional thermal stress analysis on laser scribing of glass

Coupled fluid-thermal-structural analysis during the air cooling for glass tempering

Numerical Simulation and Experimental Analysis of Thermal Conduction and Stress in Laser Cladding Repair of Thin-Walled Parts

Influences of Cooling Conditions on the Liquation Cracking in Laser Metal Deposition of a Directionally Solidified Superalloy

Crack-Free Laser Processing Of Glass Substrate And Its Mechanisms

Thick Glass High-Quality Cutting by Ultrafast Laser Bessel Beam Perforation-Assisted Separation

Effect of temperature on the ductile-to-brittle transition in laser-assisted mechanical ruling of silicon