Abstract:The quantitative measurement of viscoelasticity of nano-scaleentities is an important goal of nanotechnology research and there is considerable progress with advent of dynamic Atomic Force Microscopy. The hydrodynamics of cantilever, the force sensor in AFM measurements, plays a pivotal role in quantitative estimates of nano-scale viscoelasticity. The point-mass model,wherein the AFM cantilever is approximated as a point mass with mass-less spring is widely used in dynamic AFM analysis and its validity, particularly in liquid environments, is debated. It is suggested that the cantilever must be treated as a continuous rectangular beam to obtain accurate estimates of nano-scale viscoelasticity of materials it is probing. Here, we derived equations, which relate stiffness and damping coefficient of the material under investigation to measured parameters, by approximating cantilever as a point mass and also considering the full geometric details. These equations are derived for both tip-excited as well as base excited cantilevers. We have performed off-resonance dynamic atomic force spectroscopy on a single protein molecule to investigate the validity of widely used point-mass model. We performed measurements with AFMs equipped with different cantilever excitation methods as well as detection schemes to measure cantilever response. The data was analyzed using both, continuous-beam model and the point-mass model. We found that both models yield same results when the experiments are performed in truly off-resonance regime with small amplitudes and the cantilever stiffness is much higher than the interaction stiffness. Our findings suggest that a simple point-mass approximation based model is adequate to describe the dynamics, provided care is taken while performing experiments so that the approximations used in these models are valid.

A Preliminary Investigation of the Dynamic Response of Amplitude Modulation AFM Based on MD Simulation

Molecular Dynamics Simulation of Bimodal Atomic Force Microscopy.

Molecular Dynamics Simulation of Form Measurement Process of Soft Materials Using Atomic Force Microscope

Simulation and experimental analysis of tip response of tapping mode atomic force microscope

Investigation on the Impact of Excitation Amplitude on AFM-TM Microcantilever Beam System's Dynamic Characteristics and Implementation of an Equivalent Circuit

Analysis of Dynamic Characteristics of Cantilevers Excited at the Fixed End in Dynamic Atomic Force Microscopy in Liquid Environments

Dynamic Simulation for Cantilever of Atomic Force Microscopy under Ultrasonic Vibration

A Simulation Platform for Amplitude Modulation Atomic Force Microscope

Amplitude Modulation Atomic Force Microscopy Based on Higher Flexural Modes

Thermo-mechanical responses of a surface-coupled AFM cantilever.

Comparison of Different Excitation Schemes in Bimodal Atomic Force Microscopy in Air and Liquid Environments

Enhancing higher-order modal response in multifrequency atomic force microscopy with a coupled cantilever system

Dynamic Model of Atomic Force Microscopy in Tapping-Mode

Power Transfer in Bimodal Amplitude Modulation Atomic Force Microscopy in Liquids: A Numerical Investigation

Re-evaluation of the Widely Applied Force-Frequency Relation for Frequency-Modulation AFM under Solution

Validity of point-mass model in off-resonance dynamic atomic force microscopy

Oscillatory Motions of A Cantilever in High-Speed Atomic Force Microscopy in Constant-Height Mode

Influence of Local Material Properties on the Nonlinear Dynamic Behavior of an Atomic Force Microscope Probe

Characterization of the vibration behavior of nanobeam-resonator using AFM dynamic mode

A Novel Method to Reconstruct the Force Curve by Higher Harmonics of the First Two Flexural Modes in Frequency Modulation Atomic Force Microscope (FM-AFM).

Quantitative Formulation of Frequency-Dependent Average Force in AM-AFM