Abstract:Abstract The microwave cutoff probe (CP) is an accurate diagnostic technique to measure absolute electron density even in processing gas plasmas. Because this technique needs the installation of two probe tips and a probe body in the plasma chamber, it may cause plasma perturbation in semiconductor plasma processing; this may increase the uncertainty of the measured value. In this work, a flat CP, which is embedded in the substrate chuck or chamber wall, is proposed to measure electron density without plasma perturbation and to monitor processing plasma in real-time. We first evaluated the performance of various types of flat CPs, such as the point CP, ring CP, and bar cutoff probe (BCP), through electromagnetic (EM) field simulation. The BCP showed better performance with clearer cut-off signal characteristics and minimization of noise signals compared with the other probe types. Therefore, we focused on the characteristics of the BCP through experiments and/or EM simulations and concluded the followings: (i) the measured electron densities of the BCP agree well with those of the conventional CP; (ii) the BCP measures the plasma density near the plasma-sheath boundary layer, which is very closely adjacent to the chamber wall or wafer; (iii) it was demonstrated for the first time that the plasma density can be measured, even though the processing wafers such as un-doped silicon, P type silicon, amorphous carbon, or amorphous carbon/SiO 2 patterned wafers were placed on the flat CP; and (iv) we performed real-time measurements of the electron density using the BCP covered with the wafers in plasmas with various process gases, such as Ar, NF 3 , and O 2 . These results indicate that the chuck-embed-type or wall-type flat CP can be used as a real-time electron density measurement (monitoring) tool during industrial plasma processing, such as during etching, deposition, sputtering or implantation, and the chuck-embed-type flat CP can measure the plasma density impinging on the wafer in real-time without stopping the processing.

Measurement of the Electron Density of a Wind-Tunnel Plasma Using a Double Flush-Mounted Probe

Observation of E × B Flow Velocity Profile Change Using Doppler Reflectometry in HL-2A

Study of plasma parameters in high enthalpy ICP-heated wind tunnel by using single Langmuir probe

Research on Low Pressure Electronic Density Diagnostic Method of Single Paperback Probe Based on Langmuir Probe Theory

Electron density measurement of an ionospheric-like plasma using an impedance probe

Measurement on Electron Density of High-Power and Large-Volume ICP-heated Wind Tunnel with HCN Laser Interferometer

Electron density measurements in low-pressure plasmas using cutoff probes and comparison with hairpin and Langmuir probes

Improved analysis techniques for cylindrical and spherical double probes

Probe method to measure the electromagnetic field in a plasma by Poynting vector conversion

High-speed plasma measurements with a plasma impedance probe

Research on Plasma Electron Density Distribution Based on Microwave Diffraction

The ac-coupling between a Langmuir probe and a plasma and its effect on the plasma density measurement in the afterglow

Measurement of plasma electron energy distribution functions by Langmuir probe using a modified AC modulation method

Application of a large wall electric probe (LWEP) for plasma and ambient gas studies

Flat cutoff probe for real-time electron density measurement in industrial plasma processing

Langmuir Probe Diagnosis of a Cold Atmospheric Plasma Jet

Sampling of Plasma Plume from Atmosphere into Vacuum for Reliable Langmuir Probe Diagnostics

Optical Fiber Interferometer Application for High Electron Density Measurements on Compact Torus Plasmas.

Theoretical and Experimental Study of the Microwave Cut-off Probe for Electron Density Measurements in Low-Temperature Plasmas

2d Electron Density Profile Measurement In Tokamak By Laser-Accelerated Ion-Beam Probe

Electron Density Measurement Via Dual-Angle Thomson Scattering Diagnosis