High Sensitivity Ultraviolet Sensor Based on Gallium Oxide Coated Hollow Core Fiber

Fenglin Xian,Sen Lu,Linhua Xu,Gaige Zheng,Hong Wu,Zhaolou Cao,Shixin Pei
DOI: https://doi.org/10.1109/jsen.2024.3495637
IF: 4.3
2024-01-01
IEEE Sensors Journal
Abstract:A novel solar blind ultraviolet (UV) sensor based on a Ga 2 O 3 thin film coated hollow core fiber (HCF) is firstly proposed by theoretical and experimental methods. Ga 2 O 3 thin film is acting as an active layer to convert UV irradiation to the changes in the interference spectrum since the refractive index of Ga 2 O 3 is sensitive to UV light. An optimized 400°C annealing β-Ga 2 O 3 thin film is coated on HCF’s surface by sol-gel immerse-heating process. The surface morphology and elemental analysis shows that both Ga and O are uniformly distributed on HCF’s surface. The sensor performance is carried out under a response wavelength of 254 nm. The experimental results show that both peak position and intensity are linearly changing with the UV irradiation power increases. The sensitivities of the interference peak position and intensity are 18.9 pm/ (mW/cm 2 ) and 37.6 pm/ (mW/cm 2 ), respectively. The temperature stability measurement shows that the intensity of the interference peak linearly increases with temperature increasing from 85°C to 225°C, a sensitivity of 1.07 pm/°C is obtained. The proposed sensor has competitive sensitivity and can be applied in industrial, military and environmental regions.
What problem does this paper attempt to address?