Acoustic measurements above a plate carrying Lamb waves

Andreas Sørbrøden Talberg,Tonni Franke Johansen
DOI: https://doi.org/10.48550/arXiv.1604.02254
2016-04-08
Instrumentation and Detectors
Abstract:This article presents a set of acoustic measurements conducted on the Statoil funded Behind Casing Logging Set-Up, designed by SINTEF Petroleum Research to resemble an oil well casing. A set of simple simulations using COMSOL Multiphysics were also conducted and the results compared with the measurements. The experiments consists of measuring the pressure wave radiated of a set of Lamb waves propagating in a 3 mm thick steel plate, using the so called pitch-catch method. The Lamb waves were excited by a broadband piezoelectric immersion transducer with center frequency of 1 MHz. Through measurements and analysis the group velocity of the fastest mode in the plate was found to be 3138.5 m/s. Measuring the wave radiated into the water in a grid consisting of 8x33 measuring points, the spreading of the plate wave normal to the direction of propagation was investigated. Comparing the point where the amplitude had decreased 50 % relative to the amplitude measured at the axis pointing straight forward from the transducer shows that the wave spread out 3.2 mm after propagating 140 mm in the plate.
What problem does this paper attempt to address?