Abstract:Unidirectional generation of shear horizontal (SH) ultrasonic guided waves can be achieved using dual-coil electromagnetic acoustic transducers (EMATs), through the interference mechanism when appropriately phased signals are used to drive each EMAT coil. Optimal unidirectional generation requires precise knowledge of the intended wave mode dispersion curve, which in turn, depends on the plate's thickness. In this article, we exploit optimal unidirectional generation with a dual-EMAT in order to measure plate thickness. The proposed thickness measurement method uses a dual periodic permanent magnet (PPM) EMAT, acting as transmitter, and two conventional PPM EMAT receivers on opposite sides of the transmitter, in order to receive the forward (enhanced) and backward (weakened) generated SH ultrasonic guided waves. Then, two consecutive frequency sweeps are used to generate the SH0 and SH1 modes, in order to seek the maximum ratio of the forward-traveling wave amplitude to the backward-traveling wave amplitude. The first sweep determines the optimum operating frequency for the first wave mode, which is a necessary parameter for the next sweep. The second frequency sweep determines the plate thickness. The new method was initially evaluated with a frequency-wavenumber-domain analytical model. The proposed method showed a much higher frequency-specificity, which was assessed by a quality factor figure of merit defined by the ratio of the center frequency to the -3 dB frequency bandwidth, when compared to that obtained using the conventional method that is based solely on the amplitude of the generated wave, and is therefore less susceptible to error in the thickness estimation. The method was experimentally evaluated with a dual-PPM EMAT on aluminum plates, showing good agreement with simulations and providing more than ten-fold higher specificity than the conventional method, and accurate thickness measurements, with an error lower than 0.8%.

Air-coupled thickness measurements of stainless steel

A Novel Laser Ultrasonic Thickness Measurement Method for Metal Plate Based on Spectral Analysis

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Simultaneous Measurement of Elastic Moduli, Attenuation, Density, and Thickness of a Layer by Ultrasonic Spectroscopy Using Point-Focus Transducer

Simultaneous Measurement of Local Longitudinal and Transverse Wave Velocities, Attenuation, Density, and Thickness of Films by Using Point-Focus Ultrasonic Spectroscopy

Measurement of Plate Thickness Based on the Optimal Unidirectional Generation of Ultrasonic Waves Using Dual Electromagnetic Acoustic Transducer.

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Broadband Air-Coupled Ultrasound Emitter and Receiver Enable Simultaneous Measurement of Thickness and Speed of Sound in Solids

Simultaneous laser ultrasonic measurement of sound velocities and thickness of plates using combined mode local acoustic spectroscopy

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

Acoustic measurements above a plate carrying Lamb waves

Thickness measurement via local ultrasonic resonance spectroscopy

Real-Time Thickness Measurement Using Resonant Eddy-Current Sensor

Combination of transverse and longitudinal ultrasonic waves for plane stress measurement of steel plates

Experimental investigation of low-frequency and pulsed eddy current testing in thickness measurement

The Research and Application of Wheeled Dry-Coupling Ultrasonic Technology in Steel Plate Thickness Measurement

Mode identification of guided wave and velocity measurement on a thin metal plate

Air-Coupled Ultrasonic Lamb Wave in Situ Stress Measurement Method for Composite Plates.

Easy-to-operate thickness measurement method for steel plate using bulk-wave EMAT

High Precision Ultrasonic Measurement Method for Thin-Walled Parts

High-Resolution Ultrasonic Lamb Waves Dispersion Measurement and Plate Thickness Evaluation