Abstract:Standard ultrasonic thickness measurements require the sound velocity of the sample to be known and vice versa. We present a method, which we have termed combined mode local acoustic spectroscopy (CoMLAS) for simultaneously determining a plate's thickness and sound velocities without requiring such a priori knowledge. It is based on a combination of three guided wave modes sustained by a plate at discrete frequencies, which we generate and detect using laser ultrasound. We use a pulsed laser that is shaped into a periodic line pattern on the sample's surface to generate elastic waves and measure the response at the pattern's center with a vibrometer. The surface acoustic wave mode produces an interference peak in the response spectrum at the frequency corresponding to the wavelength matching the pattern line spacing. By limiting the total size of the excitation pattern, we can simultaneously generate two zero-group-velocity plate resonances, providing two additional peaks in the spectrum. The plate's local thickness and longitudinal and transverse sound velocities are calculated from the peak frequencies. We demonstrate the feasibility of CoMLAS on steel and aluminum sheets with a thickness of around 2mm by resolving thickness steps and temperature-induced changes in the sound velocities. Using numerical simulations and control experiments, we provide insights into the method's accuracy and limitations. The choice of excitation pattern, the method's sensitivity, and the influence of sample inhomogeneity and anisotropy are discussed. CoMLAS does not require scanning mechanics and provides local plate properties. The results shown are achieved with low-energy lasers and signal averaging. Considerations on signal-to-noise ratio indicate that a realization with available lasers of higher energy will enable single-shot measurements. This qualifies the method for use on moving samples in an industrial environment.

Multi-mode Ultrasonic Waves Focusing in a Variable Focus Technique for Simultaneous Sound-Velocity and Thickness Measurement

Simultaneous Measurement of Local Longitudinal and Transverse Wave Velocities, Attenuation, Density, and Thickness of Films by Using Point-Focus Ultrasonic Spectroscopy

Simultaneous Measurement of Elastic Moduli, Attenuation, Density, and Thickness of a Layer by Ultrasonic Spectroscopy Using Point-Focus Transducer

Numerical and Experimental Analysis of a Focused Reflected Wave in a Multi-Layered Material Based on a Ray Model.

Simultaneous Thickness, Velocity, Density, and Attenuation Measurement of a Thin Layer by Time-Resolved Acoustic Microscopy

Simultaneously Measuring Thickness, Density, Velocity and Attenuation of Thin Layers Using V(z,t) Data from Time-Resolved Acoustic Microscopy.

A Novel Laser Ultrasonic Thickness Measurement Method for Metal Plate Based on Spectral Analysis

Determination of the Multiple Local Properties of Thin Layer with High Lateral Resolution by Scanning Acoustic Microscopy.

Broadband Ultrasonic Focusing in Water with an Ultra-Compact Metasurface Lens

A Novel Technique for the Measurement of the Acoustic Properties of a Thin Linear-Viscoelastic Layer Using a Planar Ultrasonic Transducer

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Simultaneous measurement of thickness and ultrasonic wave velocity using a combination of laser-generated multiple wave modes in the thermoelastic regime

Simultaneous laser ultrasonic measurement of sound velocities and thickness of plates using combined mode local acoustic spectroscopy

Multimode Measurement of Lamb Wave Propagating on Thin Isotropic Metal Sheet by Line-Focus PVDF Transducer

Simulation of Layer Thickness Measurement in Thin Multi-Layered Material by Variable-Focus Laser Ultrasonic Testing

An ultrasonic methodology for determining the mechanical and geometrical properties of a thin layer using a deconvolution technique.

Investigation of a Multi-Element Focused Air-Coupled Transducer

Finite Element Modeling and Wave Propagation Analysis for Lens-Less Line Focus Acoustic Microscopy

Design, Fabrication of Line-focus Lens-less Polyvinylidene Fluoride Transducers and Applications on Measuring Surface Acoustic Waves with V(f, Z) Analytical Method

Theoretical and experimental study on effect of defocusing amount on thickness measurement based on laser ultrasound

Investigation of an Active Focusing Planar Piezoelectric Ultrasonic Transducer