Abstract:Conventional ultrasound inspection has been a standard non-destructive testing method for providing an in-service evaluation and noninvasive means of probing the interior of a structure. In particular, measurement of the propagation characteristics of Lamb waves allows inspection of plates that are typical components in aerospace industry. A rapid, complete non-contact hybrid approach for excitation and detection of Lamb waves is presented and applied for non-destructive evaluation of composites. An air-coupled transducer (ACT) excites ultrasonic waves on the surface of a composite plate, generating different propagating Lamb wave modes and a laser Doppler vibrometer (LDV) is used to measure the out-of-plane velocity of the plate. This technology, based on direct waveform imaging, focuses on measuring dispersive curves for A0 mode in a composite laminate and its anisotropy. A two-dimensional fast Fourier transform (2D-FFT) is applied to out-of-plane velocity data captured experimentally using LDV to go from the time-spatial domain to frequency-wavenumber domain. The result is a 2D array of amplitudes at discrete frequencies and wavenumbers for A0 mode in a given propagation direction along the composite. The peak values of the curve are then used to construct frequency wavenumber and phase velocity dispersion curves, which are also obtained directly using Snell’s law and the incident angle of the excited ultrasonic waves. A high resolution and strong correlation between numerical and experimental results are observed for dispersive curves with Snell’s law method in comparison to 2D-FFT method. Dispersion curves as well as velocity curves for the composite plate along different directions of wave propagation are measured. The visual read-out of the dispersion curves at different propagation directions as well as the phase velocity curves provide profiling and measurements of the composite anisotropy. The results proved a high sensitivity of the air-coupled and laser ultrasound technique in non-contact characterization of Lamb wave dispersion and material anisotropy of composite plates using simple Snell’s law method.

Measurement of the effects of rough surfaces on Lamb waves propagation

Acoustic measurements above a plate carrying Lamb waves

Propagation of Lamb waves in a metal plate with an abrupt change in thickness using Peridynamics and laser Doppler velocimetry

Development of interdigital transducer sensors for non-destructive characterization of thin films using high frequency Rayleigh waves

Riblet Sensor -- Light Scattering on Micro Structured Surface Coatings

Underwater acoustic surface waves on a periodically perforated metal plate

Evaluation of the Influence of Surface Roughness Parameters on Ultrasonic Rayleigh Waveforms

Analysis of coherent surface wave dispersion and attenuation for non-destructive testing of concrete

Laser Ultrasonic Measurements for Generation and Detection of Lateral Waves in a Solid for Surface Defect Inspection

Surface Effects on Frequency Dispersion Characteristics of Lamb Waves in a Nanoplate

Air-coupled, focused ultrasonic dispersion spectrum reconstruction in plates

Non contact probing of interfacial stiffnesses between two plates by Zero-Group Velocity Lamb modes

Simulation-Based Characterization of Mechanical Parameters and Thickness of Homogeneous Plates Using Guided Waves

Experimental and Theoretical Analyses on Laser-Generated Transient Lamb Waves in an Orthotropic Plate

Non-Contact Surface Roughness Measurement by Implementation of a Spatial Light Modulator

A new methodology of Non-Destructive Testing in a set of two parallel immersed plates using time reversal process and Leaky Lamb waves

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

The excitation and detection of Lamb waves in a droplet-loaded plate using air-coupled ultrasonic transducers

A method for crack sizing using Laser Doppler Vibrometer measurements of Surface Acoustic Waves

A novel methodology to assess optical profilometer stability to discriminate surface roughness

Monitoring the Crack Growth by Measurement of Diffracted Lamb Waves