Abstract:Conventional ultrasound inspection has been a standard non-destructive testing method for providing an in-service evaluation and noninvasive means of probing the interior of a structure. In particular, measurement of the propagation characteristics of Lamb waves allows inspection of plates that are typical components in aerospace industry. A rapid, complete non-contact hybrid approach for excitation and detection of Lamb waves is presented and applied for non-destructive evaluation of composites. An air-coupled transducer (ACT) excites ultrasonic waves on the surface of a composite plate, generating different propagating Lamb wave modes and a laser Doppler vibrometer (LDV) is used to measure the out-of-plane velocity of the plate. This technology, based on direct waveform imaging, focuses on measuring dispersive curves for A0 mode in a composite laminate and its anisotropy. A two-dimensional fast Fourier transform (2D-FFT) is applied to out-of-plane velocity data captured experimentally using LDV to go from the time-spatial domain to frequency-wavenumber domain. The result is a 2D array of amplitudes at discrete frequencies and wavenumbers for A0 mode in a given propagation direction along the composite. The peak values of the curve are then used to construct frequency wavenumber and phase velocity dispersion curves, which are also obtained directly using Snell’s law and the incident angle of the excited ultrasonic waves. A high resolution and strong correlation between numerical and experimental results are observed for dispersive curves with Snell’s law method in comparison to 2D-FFT method. Dispersion curves as well as velocity curves for the composite plate along different directions of wave propagation are measured. The visual read-out of the dispersion curves at different propagation directions as well as the phase velocity curves provide profiling and measurements of the composite anisotropy. The results proved a high sensitivity of the air-coupled and laser ultrasound technique in non-contact characterization of Lamb wave dispersion and material anisotropy of composite plates using simple Snell’s law method.

Air-coupled, focused ultrasonic dispersion spectrum reconstruction in plates

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

High-Resolution Ultrasonic Lamb Waves Dispersion Measurement and Plate Thickness Evaluation

Group Delay Dispersion Measurement of a Dispersive Mirror by Spectral Interferometry: Comparison of Different Signal Processing Algorithms.

Determination of lamb wave dispersion data in lossy anisotropic plates using time domain finite element analysis. Part I: theory and experimental verification

Simultaneous Measurement of Local Longitudinal and Transverse Wave Velocities, Attenuation, Density, and Thickness of Films by Using Point-Focus Ultrasonic Spectroscopy

Linearly Dispersive Signal Construction of Lamb Waves with Measured Relative Wavenumber Curves

Effective Time-Frequency Characterization of Lamb Wave Dispersion in Plate-Like Structures with Non-Reflecting Boundaries

Angular Measurement of Acoustic Reflection Coefficients by the Inversion of V(z, T) Data with High Frequency Time-Resolved Acoustic Microscopy

Electroelastic guided wave dispersion in piezoelectric plates: spectral methods and laser-ultrasound experiments

Measurement of circumferential Lamb waves using a line-focus poly(vinylidene fluoride) transducer and cross correlation waveform analysis.

Simulation-Based Characterization of Mechanical Parameters and Thickness of Homogeneous Plates Using Guided Waves

Simultaneous Measurement of Elastic Moduli, Attenuation, Density, and Thickness of a Layer by Ultrasonic Spectroscopy Using Point-Focus Transducer

Dispersion of Lamb waves in a honeycomb composite sandwich panel

Numerical Simulation for Dispersion Characteristics of Lamb Wave Propagation in Composite Laminates with Anti-Symmetric Surface Excitation

Reconstruction of Lamb Wave Dispersion Curves by Sparse Representation with Continuity Constraints.

High-resolution Lamb waves dispersion curves estimation and elastic property inversion

Experiment Investigations of Lamb Waves in an Aluminum Plate

Time-frequency representation of Lamb waves using the reassigned spectrogram

Experimental and Theoretical Analyses on Laser-Generated Transient Lamb Waves in an Orthotropic Plate

A Bayesian Method for Material Identification of Composite Plates via Dispersion Curves