Abstract:Most previous studies on nonlinear Lamb waves are conducted using mode pairs that satisfying strict phase velocity matching and non-zero power flux criteria. However, there are some limitations in existence. First, strict phase velocity matching is not existed in the whole frequency bandwidth; Second, excited center frequency is not always exactly equal to the true phase-velocity-matching frequency; Third, mode pairs are isolated and quite limited in number; Fourth, exciting a single desired primary mode is extremely difficult in practice and the received signal is quite difficult to process and interpret. And few attention has been paid to solving these shortcomings. In this paper, nonlinear S0 mode Lamb waves at low-frequency range satisfying approximate phase velocity matching is proposed for the purpose of overcoming these limitations. In analytical studies, the secondary amplitudes with the propagation distance considering the fundamental frequency, the maximum cumulative propagation distance (MCPD) with the fundamental frequency and the maximum linear cumulative propagation distance (MLCPD) using linear regression analysis are investigated. Based on analytical results, approximate phase velocity matching is quantitatively characterized as the relative phase velocity deviation less than a threshold value of 1%. Numerical studies are also conducted using tone burst as the excitation signal. The influences of center frequency and frequency bandwidth on the secondary amplitudes and MCPD are investigated. S1–S2 mode with the fundamental frequency at 1.8 MHz, the primary S0 mode at the center frequencies of 100 and 200 kHz are used respectively to calculate the ratios of nonlinear parameter of Al 6061-T6 to Al 7075-T651. The close agreement of the computed ratios to the actual value verifies the effectiveness of nonlinear S0 mode Lamb waves satisfying approximate phase velocity matching for characterizing the material nonlinearity. Moreover, the ratios derived from the primary and secondary horizontal displacements generated from nonlinear S0 mode Lamb waves are closest to the real value, which indicates that using horizontal displacements is more suitable for detecting evenly distributed microstructural changes in large thin plate-like structure. Successful application to evaluating material at different levels of evenly distributed fatigue damage is also numerically conducted.

An accurate measurement method of lamb wave phase velocity based on clustering algorithms

THE ESTIMATION OF THE LAMB WAVE PHASE VELOCITY DISPERSION CURVES BASE ON K- MEANS CLUSTERING ALGORITHM

An Algorithm Based on Logarithm of Wavenumber Amplitude for Detection of Delamination in Carbon Fiber Composite

A Novel Laser Ultrasonic Thickness Measurement Method for Metal Plate Based on Spectral Analysis

High-Resolution Ultrasonic Lamb Waves Dispersion Measurement and Plate Thickness Evaluation

Non-destructive measurements of thickness and elastic constants of plate structures based on Lamb waves and particle swarm optimization

Analytical and numerical studies of approximate phase velocity matching based nonlinear S0 mode Lamb waves for the detection of evenly distributed microstructural changes

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

High-resolution Lamb waves dispersion curves estimation and elastic property inversion

Multi-time Lamb waves space wavenumber imaging method based on ultrasonic-guided wavefield

Research on Delamination Damage Localization of Carbon Fiber-Reinforced Polymer Curved Plate Using Lamb Wave

A Method of Dispersion Compensation Based on Warped Frequency Transform

Analytical computation of the dominant dispersion trend of Lamb waves in plate‐like structures with an improved dynamic stiffness matrix method

Detection and localization of closely distributed damages via lamb wave sparse reconstruction

Research on Delamination Damage Quantification Detection of CFRP Bending Plate Based on Lamb Wave Mode Control

Nondestructive Testing Method Based on Lamb Waves for Localization and Extent of Damage

A Damage Localization Method With Multimodal Lamb Wave Based on Adaptive Polynomial Chirplet Transform

Attenuation characteristics of Lamb wave in carbon fiber reinforced composite laminated plate

Application of Damage Detection of Metal Structure Lamb Wave Modal Superposition Imaging Based on Scanning Laser Vibration Measurement

Determination of lamb wave dispersion data in lossy anisotropic plates using time domain finite element analysis. Part I: theory and experimental verification

Relative reflection intensity of Lamb waves from elliptically-shaped damages in metallic plates