Abstract:Conventional ultrasound inspection has been a standard non-destructive testing method for providing an in-service evaluation and noninvasive means of probing the interior of a structure. In particular, measurement of the propagation characteristics of Lamb waves allows inspection of plates that are typical components in aerospace industry. A rapid, complete non-contact hybrid approach for excitation and detection of Lamb waves is presented and applied for non-destructive evaluation of composites. An air-coupled transducer (ACT) excites ultrasonic waves on the surface of a composite plate, generating different propagating Lamb wave modes and a laser Doppler vibrometer (LDV) is used to measure the out-of-plane velocity of the plate. This technology, based on direct waveform imaging, focuses on measuring dispersive curves for A0 mode in a composite laminate and its anisotropy. A two-dimensional fast Fourier transform (2D-FFT) is applied to out-of-plane velocity data captured experimentally using LDV to go from the time-spatial domain to frequency-wavenumber domain. The result is a 2D array of amplitudes at discrete frequencies and wavenumbers for A0 mode in a given propagation direction along the composite. The peak values of the curve are then used to construct frequency wavenumber and phase velocity dispersion curves, which are also obtained directly using Snell’s law and the incident angle of the excited ultrasonic waves. A high resolution and strong correlation between numerical and experimental results are observed for dispersive curves with Snell’s law method in comparison to 2D-FFT method. Dispersion curves as well as velocity curves for the composite plate along different directions of wave propagation are measured. The visual read-out of the dispersion curves at different propagation directions as well as the phase velocity curves provide profiling and measurements of the composite anisotropy. The results proved a high sensitivity of the air-coupled and laser ultrasound technique in non-contact characterization of Lamb wave dispersion and material anisotropy of composite plates using simple Snell’s law method.

Determination of lamb wave dispersion data in lossy anisotropic plates using time domain finite element analysis. Part I: theory and experimental verification

Determination of Lamb Wave Phase Velocity Dispersion Using Time–frequency Analysis

Effective Time-Frequency Characterization of Lamb Wave Dispersion in Plate-Like Structures with Non-Reflecting Boundaries

The Dispersion Curves and Wave Structures of Lamb Waves in Functionally Graded Plate: Theoretical and Simulation Analysis

Analytical Solutions for Forced Vibration and Dispersion Property of Periodic Multilayer Elastically Connected Plate Structures

Analysis of Lamb Wave Propagation in a Functionally Graded Piezoelectric Small-Scale Plate Based on the Modified Couple Stress Theory

Electroelastic guided wave dispersion in piezoelectric plates: spectral methods and laser-ultrasound experiments

Experimental and Theoretical Analyses on Laser-Generated Transient Lamb Waves in an Orthotropic Plate

Lamb wave dispersion and anisotropy profiling of composite plates via non-contact air-coupled and laser ultrasound

Numerical Simulation of Lamb Wave Propagation in Isotropic Materials with Different Plate Thicknesses

Numerical Simulation for Dispersion Characteristics of Lamb Wave Propagation in Composite Laminates with Anti-Symmetric Surface Excitation

Air-coupled, focused ultrasonic dispersion spectrum reconstruction in plates

Simulation-Based Characterization of Mechanical Parameters and Thickness of Homogeneous Plates Using Guided Waves

Anisotropic Behavior Analyzed by Laser-Generated Lamb Waves for Fiber Composite Plates

Lamb Waves Propagation Characteristics in Functionally Graded Sandwich Plates

Modelling Guided Waves in Anisotropic Plates Using the Legendre Polynomial Method

Experimental determination of Lamb wave dispersion diagrams over large frequency ranges in fiber metal laminates

Low-frequency propagating and evanescent waves in strongly inhomogeneous sandwich plates

A Comprehensive Study on Guided Wave Dispersion in Complex Structures

Wave dispersion relations in laminated fiber-reinforced composite plates with surface-mounted piezoelectric materials

Modeling Guided Wave Propagation in Multi-Layered Anisotropic Composite Laminates by State-Vector Formalism and the Legendre Polynomials