Abstract:The influence of the synthesis method parameters used to prepare nickel-based catalysts on the catalytic performance for the glycerol steam reforming reaction was studied. A series of Al2O3-supported Ni catalysts were synthesized, with nickel loading of 8 wt%, using the incipient wetness, wet impregnation, and modified equilibrium deposition filtration methods. The catalysts' surface and bulk properties were determined by inductively coupled plasma (ICP), N2 adsorption-desorption isotherms (BET), X-ray diffraction (XRD), scanning electron microscopy (SEM), transmission electron microscopy (TEM), and temperature-programmed reduction (TPR). Used catalysts were characterized by techniques such as elemental analysis and SEM in order to determine the level of carbon that was deposited and catalyst morphology. The results indicated that the synthesis method affected the textural, structural and surface properties of the catalysts, differentiating the dispersion and the kind of nickel species on alumina's surface. The formation of nickel aluminate phases was confirmed by the XRD and TPR analysis and the β-peak of the Ni/Al-edf catalyst was higher than in the other two catalysts, indicating that the nickel aluminate species of this catalyst were more reducible. Both Ni/Al-wet and Ni/Al-edf catalysts showed increasing CO2 selectivities and approximately constant CO selectivities for temperatures above 550 °C, indicating that these catalysts successfully catalyze the water gas shift reaction. It was also confirmed that the Ni/Al-edf catalyst had the highest values for glycerol to gaseous products conversion, hydrogen yield, allyl alcohol, acetaldehyde, and acetic acid selectivities at 650 °C and the lowest carbon deposition of the catalysts tested. The correlation of the catalysts' structural properties, dispersion and reducibility with catalytic performance reveals that the EDF method can provide catalysts with higher specific surface area and active phase's dispersion, that are easier to reduce, more active and selective to hydrogen production, and more resistant to carbon deposition.

Foamed Ceramic Based Γ-Al₂o₃ Coated Catalysts with Different Preparation Methods for Ethyl Nicotinate Hydrogenation Reaction

Sol-Gel Preparation, Characterization and Hydrogenation Property of Silica Supported Ni Catalyst

Hydrogen Production from Partial Oxidation of Propane: Effect of SiC Addition on Ni/Al2O3 Catalyst

Nickel Nanoparticles Embedded in Porous Carbon-Coated Honeycomb Ceramics: A Potential Monolithic Catalyst for Continuous Hydrogenation Reaction

Effect of support texture properties on Ni-Fe/γ-Al_2O_3 catalyst structure and catalytic performance for CO methanation

Regulating Pd/Al2o3 Catalyst By G-C3n4 Toward The Enhanced Selectivity Of Isoprene Hydrogenation

Promotion of Ni/MCM-41 Catalyst for Hydrogenation of Naphthalene by Co-Impregnation with Polyols

Development of a Novel Structured Mesh-Type Pd/γ-Al2O3/Al Catalyst on Nitrobenzene Liquid-Phase Catalytic Hydrogenation Reactions

Carbon-coated Ni-Co alloy catalysts: preparation and performance for in-situ aqueous phase hydrodeoxygenation of methyl palmitate to hydrocarbons using methanol as the hydrogen donor

High-Performance Ni3P Catalyst for C═O Hydrogenation of Ethyl Levulinate: Niδ+ As Outstanding Adsorption Sites

Preparation of highly active and hydrothermally stable nickel catalysts.

Effect of Supports on the Supported Ni2P Catalysts Prepared by the Phosphidation Using Triphenylphosphine in Liquid Phase

Nanoporous Ni3P evolutionarily structured onto a Ni-foam for highly selective hydrogenation of dimethyl oxalate to methyl glycolate.

Preparation of Highly Effective Ni Foam Monolithic Catalysts by Electrolytic Deposition for Nitrobenzene Hydrogenation in a Micropacked Bed

Novel Nanostructured Pd/Co-Alumina Materials for the Catalytic Oxidation of Atmospheric Pollutants

Influence of the synthesis method parameters used to prepare nickel-based catalysts on the catalytic performance for the glycerol steam reforming reaction

Preparation of Pd/Al2O3/Nickel Microfoam Catalysts by Electrodeposition for Hydrogenation in a Micropacked Bed Reactor

Synthesis of Pdni Catalysts for the Oxidation of Ethanol in Alkaline Direct Ethanol Fuel Cells

Significant effect of In doping on Ni/C catalyst for hydrogenation of dimethyl oxalate to ethanol: Synergistic effect of InNi 3 alloy, surface oxygen, and defect sites

Electrocatalytic Performance of Ethanol Oxidation on Ni and Ni/Pd Surface-Decorated Porous Structures Obtained by Molten Salts Deposition/Dissolution of Al-Ni Alloys

Effects of Ni(OH)2 Morphology on the Catalytic Performance of Pd/Ni(OH)2/Ni Foam Hybrid Catalyst Toward Ethanol Electrooxidation