Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

A New Analytical Model for Predicting the Welding Deformation of Large Welded Plates with Equivalent Moments

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Welding Distortion Prediction and Mitigation in Thick Steel Plate Structures on Ships

Welding-induced Buckling Prediction for Large Thin-Walled Cylindrical Structures with Non-Uniform Stress Fields by Friction Stir Welding

Prediction of welding deformation of large complicated structure based on inherent strain methods

Recent Research on Welding Distortion Prediction in Thin Plate Fabrication by Means of Elastic FE Computation

Prediction of Welding Deformation and Residual Stress in A Multiply-Stiffened Plate

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Prediction of deformation of large welding fabrication based on inherent strain

Prediction and Application of Welding Residual Deformation of Steel Sheets

Influence of Initial Structural Dimensions of Plates on Welding Distortion

Evaluation Method for Inherent Deformation and its Application in Predicting Welding Distortion on Hull Blocks

Prediction for Welding Deformation Reducing by Welding Sequence Optimization of Upper Plate

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Study of Welding Inherent Deformations in Thin Plates Based on Finite Element Analysis Using Interactive Substructure Method

Application of Inertia Relief in the Prediction of Welding Deformation for Large Complex Structures

Numerical Analysis on Optimizing Welding Sequence of Large-Sized Bottom Structure for Controlling Welding Distortion

Welding Distortion Prediction In 5a06 Aluminum Alloy Complex Structure Via Inherent Strain Method