Abstract:An accurate temperature analysis of electronic packaging requires an understanding of the thermal-transport parameters of the material. However, studies on the thermal conductivity of intermetallic compounds (IMCs) in micro-interconnect solder joints are scarce, particularly common IMCs forming in Cu-Sn systems, which seriously affect the precise prediction of the temperature field and thermal stress for electronic packaging structures. This work proposes a novel method to quantitatively measure the thermophysical parameters of Cu-Sn IMCs based on the dual-wavelength femtosecond laser timedomain thermoreflectance (TDTR) system. Cu-Sn diffusion couple samples were prepared using a reflow and aging process. Two layers of Cu6Sn5 and Cu3Sn IMCs formed at the interface with micron thickness, and the (001) crystal plane of Cu6Sn5 was the preferred orientation. The sensitivity of the experimental parameters to the measurement parameters affects the fitting accuracy. Therefore, before testing, the effects of the aluminum transducer thickness and pump laser modulation frequency on the phase signal sensitivity in the thermal conductivity measurements of Cu6Sn5 and Cu3Sn were analyzed to help select the specific experimental parameters. After testing, the thermal conductivities of Cu6Sn5 and Cu3Sn were 47.4 and 87.6 W/(m center dot K), respectively, which are slightly higher than the previous results because of the microstructure discrepancy caused by different material preparation techniques. Finally, the influence of the pump laser diameter, aluminum transducer thickness, and material specific heat on the measurement error of thermal conductivity for Cu6Sn5 and Cu3Sn was examined. The test errors of the Cu6Sn5 and Cu3Sn thermal conductivity were -6.8%similar to 4.6% and -7.1%similar to 4.4%, respectively. Overall, the TDTR technology can evaluate the thermal-transport characteristics of micron-scale intermetallic compounds in electronic packaging and guide the thermal design and reliability evaluations of electronic components.

A Novel Steady-State Method for Measuring Thermal Conductivity of Thermal Interface Materials with Miniaturized Thermal Test Chips

A Novel Method For On-Line Junction Temperature Measurement Of Power Modules

The Study of Novel Metal/composite Thermal Interface Materials for Chip Testing

Thermal conductivity and contact resistance measurements for thermal interface materials

Thermal Visualization of Buried Interfaces by Transient and Steady-State Responses of Time-Domain Thermoreflectance

Spatial Thermal Conductivity Variation of Particulate-Filled Thermal Interface Materials

Design and Test of a Low Junction-to-Case Thermal Resistance Packaging Method

Simultaneous Measurement of Thermal Conductivity and Volumetric Heat Capacity of Thermal Interface Materials Using Thermoreflectance

Thermal Visualization of Buried Interfaces Enabled by Ratio Signal and Steady-State Heating of Time-Domain Thermoreflectance

Study of LED Thermal Resistance and TIM Evaluation Using LEDs with Built-in Sensor

Investigations on the Thermal Conductivity of Micro-Scale Cu-Sn Intermetallic Compounds Using Femtosecond Laser Time-Domain Thermoreflectance System

A Novel Heat Transfer Characterization Method for a Thermal Management Scheme of 3D-Ic Chips

Realizing the Accurate Measurements of Thermal Conductivity over a Wide Range by Scanning Thermal Microscopy Combined with Quantitative Prediction of Thermal Contact Resistance.

Improvement of interfacial thermal resistance between TIMs and copper for better thermal management

An improved steady-state method for measuring the thermal contact resistance and bulk thermal conductivity of thin-walled materials having a sub-millimeter thickness

A Review of Carbon-Based Thermal Interface Materials: Mechanism, Thermal Measurements and Thermal Properties

Numerical and Experimental Studies on the In-Situ Measurement of Thermal Conductivity of the Thermal Barrier Coating

New Nano-Thermal Interface Material for Heat Removal in Electronics Packaging

Utility of transient testing to characterize thermal interface materials

Exploring modeling and testing approaches for three-dimensional integrated thermal resistance of chiplets

Simultaneous measurement of cross-plane thermal conductivity and interfacial thermal conductance of nano-metal films on a low thermal diffusivity substrate using TDTR