Input Signal Distribution Using Coupled Lambda/2 Standing-Wave Oscillators For Coherent Power Combining
Yingqian Huang,Xi Zi,Jinfang Zhou,Kangsheng Chen
2011-01-01
Abstract:One of the key challenges to realize a fully integrated transceiver using silicon based processes is the limited output power achievable, especially at millimeter-wave frequencies. Higher output power can be obtained by using various power combining schemes, which typically sum the output power of N identical amplifying stages coherently. Thus to ensure efficient power combining, the input signal must be distributed to all the amplifying stages on the chip with equi-phase and equi-magnitude. While Wilkinson power splitter has been employed for this purpose in the literatures, it becomes bulky and inefficient when N is large, which severely limits the number of outputs that can be combined.In this paper, a network of coupled lambda/2 standing-wave oscillators is employed to distribute the input signal. Proposed formerly for global clock distribution, theoretically, differential signals of equi-frequency, equi-phase, and equi-magnitude can be obtained by taping onto specific points in the network. It should be noted, however, that the network is especially suited for input signal distribution purpose here, since the specific power combining scheme assumes that a grid of N amplifying stages resides on the chip, which matches to the tap points in a perfect way.A 30 GHz prototype network comprised of four coupled lambda/2 standing-wave oscillators using TSMC 0.18 mu m CMOS process has been design. Post-layout simulation results are presented showing that no distinguishable difference in frequency, phase, and amplitude is observed for the multiple output differential signals. The chip has a total area (including pads) of 800 x 990 mu m(2) and has been submitted for fabrication.