Abstract:First-principles calculation and experimental methods are used to study the interfacial properties and reaction of diamond/Al composites. Based on the first-principles method, the interfacial adhesion work (W-ad), electronic structure and charge transfer of diamond/Al models are calculated systematically. The results show that the adhesion work of diamond(100)/Al(111) is 41% higher than that of diamond(111)/Al(111), therefore, the interface bonding of diamond(100)/Al(111) interface is stronger. According to the analysis of the electronic structure, there are more charges transferring at the diamond(100)/Al(111) interface, and the high charge density is distributed on the side of C atoms. The redistribution of charges at the interface is conducive to the formation of Al-C bond, so that the tendency of forming Al-C bonds is greater. The introduction of Al-C bond can promote the formation of C- C bond at the diamond(100)/Al(111) interface and improve the interfacial adhesion work. In addition, the diamond/Al composites are fabricated by vacuum gas pressure infiltration, and multi-scale characterization of the interface structure of diamond/Al composites is carried out. The interfacial debonding occurs mainly on the diamond {111}. Meanwhile, the interface product Al4C3 is easier to form on the diamond {100}. The experimental phenomenon is consistent with the calculated results. Moreover, the influence of the interfacial reaction on the properties and stability of diamond/Al composites are further discussed through heat-moisture treatment. The study finds that the performance degradation in heat-moisture environment is related mainly to the hydrolysis of the interface product Al4C3. After 60 days' heat-moisture, the thermal conductivity of the diamond/Al composites decreases by 29.9%, and the bending strength is reduced by 40.1%. The large attenuation of performance is not conducive to the stability of composites in complex environments. Therefore, inhibiting the formation of Al4C3 and improving interfacial selectivity are of great importance in developing the performance and stability of diamond/Al composites. The research in this paper not only lays a theoretical foundation for the first-principles calculation of the interface properties of diamond/metal, but also possesses important guidance significance in designing the diamond/metal composites.

Study on the Stability of Fe/Al2O3 Interface in Metal-Based Cermets Using Thermodynamic Modeling

Evaluation of Interfacial Stability and Strength of Cermets Based on Work Function

Manipulating interface bonding and microstructure via tuning interfacial reaction for enhancing mechanical property of in-situ TiC/Al cermets

Wettability At Al-Mg/Cerarnic Interfaces

Microstructure and Properties of Ti(C,N)-Based Cermets with AlxCoCrFeNiTi Binder

Microstructure and Properties of Porous Ni50Cr50- Al2O3 Cermet Support for Solid Oxide Fuel Cells

Effects of active elements on adhesion of the Al2O3/Fe interface: A first principles calculation

A Comparable Study of Fe//MCs (M = Ti, V) Interfaces by First-Principles Method: the Chemical Bonding, Work of Adhesion and Electronic Structures

First-principles calculations of γ-Al2O3/Al interfaces

Chemical bonding, thermodynamic stability and mechanical strength of Ni3Ti/α-Al2O3 interfaces by first-principles study

Interface properties of Ti3SiC2/Al2O3 ceramics: Combined experiments and first-principles calculations

Effect of Fe on the Microstructure and Mechanical Properties of Fe/FeAl2O4 Cermet Prepared by Hot Press Sintering

Characterization and Formation Mechanisms of the TiC-Fe Cermet Layer in Ti-TiC-Fe Composites

First-principles Calculation of Diamond/al Interface Properties and Study of Interface Reaction

Exploring failure mode and enhancement mechanism of doped rare-earth elements iron-based/alumina-ceramic interface

First-principles investigation of interface atomic arrangement and segregation behavior of solute elements in Al/TiC interface in TiC/2219 composites

Influence of C and Al Addition on Microstructure and Mechanical Properties of Ultrafine TiCN-Based Cermets

Interface Calculation of In Situ Micro-Nano TaC/NbC Ceramic Particle Composites

Investigation of Al/CeO2 interfacial relationships for epitaxial growth of Al on CeO2 substrates: first-principles calculation

Atomistic study of intermetallics of Fe-Al-Zn system and their interfacial properties

Interfacial structure of WC-Fe metal-matrix composite (WC/Fe3W3C and Fe/Fe3W3C) stability, electronic and mechanical properties from first-principles calculations