Abstract:This study performed first-principle-based calculations of the interface adhesion work in interface models of three terminal systems: CrAlSiNSi/WC-Co, CrAlSiNN/WC-Co, and CrAlSiNAl/WC-Co. The results proved that the CrAlSiNSi/WC-Co and CrAlSiNAl/WC-Co interface models had the highest and lowest interface adhesion work values (4.312 and 2.536 J·m−2), respectively. Thus, the latter model had the weakest interface bonding property. On this basis, rare earth oxides CeO2 and Y2O3 were doped into the Al terminal model (CrAlSiNAl/WC-Co). Then, doping models of CeO2 and Y2O3 doped on the WC/WC, WC/Co, and CrAlSiNAl/WC-Co interfaces were established. The adhesion work value was calculated for the interfaces in each doping model. When CeO2 and Y2O3 were doped in the WC/WC and CrAlSiNAl/WC-Co interfaces, four doping models were constructed, each model contains interfaces withreduced adhesion work values, indicating deteriorated interface bonding properties. When the WC/Co interface was doped with CeO2 and Y2O3, the interface adhesion work values of the two doping models are both increased, and Y2O3 doping improved the bonding properties of the Al terminal model (CrAlSiNAl/WC-Co) more significantly than CeO2 doping. Next, the charge density difference and the average Mulliken bond population were estimated. The WC/WC and CrAlSiNAl/WC-Co interfaces doped with CeO2 or Y2O3, with decreased adhesion work, exhibited low electron cloud superposition and reduced values of charge transfer, average bond population, and interatomic interaction. When the WC/Co interface was doped with CeO2 or Y2O3, superposition of the atomic charge densities of electron clouds was consistently observed at the CrAlSiNAl/WC-Co interface in the CrAlSiNAl/WC/CeO2/Co and CrAlSiNAl/WC/Y2O3/Co models; the atomic interactions were strong, and the interface bonding strength increased. When the WC/Co interface was doped with Y2O3, the superposition of atomic charge densities and the atomic interactions were stronger than for CeO2 doping. In addition, the average Mulliken bond population and the atomic stability were also higher, and the doping effect was better.

Interface properties of Ti3SiC2/Al2O3 ceramics: Combined experiments and first-principles calculations

Tensile Properties and Fracture Mechanism of the Ti2AlC(0001)/TiAl(111) Interface: Insights from a First-Principles Study

Electronic and mechanical properties of Al (100)/6H–SiC (0001) interfaces: a first-principles study

Manipulating interface bonding and microstructure via tuning interfacial reaction for enhancing mechanical property of in-situ TiC/Al cermets

First-principles calculations of the effects of the interface microstructure on the wettability of a Cu–Ti/AlN system

Preparation and properties of Al2O3/Al-2(1-0.2)Mg0.2Ti(1+0.2)O5 matrix ceramic composite

The interface-layer and interface in the Al2O3/Ti3SiC2 multilayer composites prepared by in situ synthesis

Theoretical analysis of Si3N4/TiC interfacial properties and material preparation

First-principles study of the Ti(0001)/TiAl 3 (110) interfacial properties

First-principle calculations on the structure of 6H-SiC/Al interface

Interface Bonding Properties of CrAlSiN-Coated Cemented Carbides Doped with CeO2 and Y2O3 Rare Earth Oxides

First-principles investigation of interface atomic arrangement and segregation behavior of solute elements in Al/TiC interface in TiC/2219 composites

First-principles study of interfaces in Al/SiC metal-matrix composite system

Electronic structures and properties of TiAl/Ti2AlNb heterogeneous interfaces: A comprehensive first-principles study

Chemical bonding, thermodynamic stability and mechanical strength of Ni3Ti/α-Al2O3 interfaces by first-principles study

Interface Calculation of In Situ Micro-Nano TaC/NbC Ceramic Particle Composites

First principles calculations on Al/TiB 2 interfaces

Mechanical Properties and Microstructure of Al<sub>2</sub>O<sub>3</sub>-Ti<sub>3</sub>SiC<sub>2</sub> Ceramic Composites

Stability of the Al/TiB2 Interface and Doping Effects of Mg/Si

Experimental and first-principles study on TiB/TiC interface in hybrid (TiB+TiC)/Ti6Al4V composite

Effects of doping Ti3SiC2 with Al on interfacial microstructural evolution, growth kinetics and mechanical properties of Ti3SiC2/TiAl joints