Abstract:Mechanism analysis, process optimisation and validation of laser surface treatment. Adhesive bonding has gradually replaced mechanical connections as the primary method for composite material bonding, with surface quality being the key factor determining the effectiveness of composite material adhesion. Laser surface treatment, known for its green and precise characteristics, has garnered widespread attention from both academia and industry. However, the process parameters of laser surface treatment are complex, efficiency is low, and the mechanism remains unclear. This paper, based on the response surface methodology (RSM), investigates the influence of laser secondary parameters on the resin removal rate of carbon fiber reinforced polymer/plastic (CFRP) surfaces and the impact of defocusing on surface treatment efficiency. The results indicate that when the total laser energy density (Et) is 69 J/cm2, the overlap ratio in the warp direction (OLs) is 76%, and the overlap ratio in the weft direction (OLh) is 85%, the surface tensile shear strength increases by 90.59% and 27.77% compared to the original surface and polished surface, respectively. When the defocus distance is +8 mm, the efficiency of laser surface treatment is 2.25 times that of non‐defocus, with minimal impact on mechanical performance. The surface treatment mechanism, with changes in Et, primarily involves the pure thermal decomposition of the resin matrix in an oxygen‐free environment, oxidative decomposition, and the synergistic action of the decomposition products' oxidation. Through the coupled optimization of laser process parameters, this work enhances the efficiency and effectiveness of composite material adhesive surface treatment, promoting the engineering application of laser technology. Highlights By establishing a response surface model, the study elucidated the impact patterns of laser secondary parameters (overlap rates in the warp and weft directions, total energy density) on the resin removal rate of CFRP surfaces. Based on the laser surface treatment phenomena at different total energy densities, the study analyzed and revealed the mechanism of near‐infrared (1064 nm) laser resin removal from CFRP surfaces. By increasing the spot size through defocusing, the efficiency of laser surface treatment was enhanced, and the impact on the interfacial properties of CFRP after defocused treatment was validated.

Optimization of Laser-Based Glass Frit Bonding for Optoelectronic Packaging Using Response Surface Methodology

Application of Orthogonal Test in Numerical Simulation of Glass Lens Molding

Optimization of the Femtosecond Laser Machining Process for Single Crystal Diamond Using Response Surface Methodology

Multiple-response surface optimization of IMCs layer in Au–Sn laser transmission bonding process

Process optimization and performance verification of CFRP laser surface modification

Optical Properties of Direct Wafer Bonded Micro-Cavity Structures

Bonding of Glass-Based Microfluidic Chips at Low- or Room-Temperature in Routine Laboratory

Measure for optical robustness of directly bonded glass-to-glass joint using its interaction with damage induced by fs laser

Optimized Sealing Process And Real-Time Monitoring Of Glass-To-Metal Seal Structures

A study of welding process in connecting borosilicate glass by picosecond laser pulses based on response surface methodology

Laser Bonding of Glass and Glass with Constant Temperature Output

The effect of gap on the quality of glass-to-glass welding using a picosecond laser

Application and Optimization of Laser-Assisted Bonding (LAB) in Multi-Chip Integration

Finite Element Analysis of Weld Area in Spot Bonding Process to Predict Bond Strength in Transparent Materials Using Ultrafast Lasers

Study of the thermo-mechanical behavior of glass interposer for flip chip packaging applications

Glass Frit Jetting for Advanced Wafer-Level Hermetic Packaging

Laser-Assisted Bonding (LAB), Its Bonding Materials, and Their Applications

Formation mechanism of pore defects and surface ripples under different process parameters via laser powder bed fusion by numerical simulation and experimental verification

Investigation of the effects of process parameters on the glass-to-mold sticking force during precision glass molding

Rapid Fabrication of Smooth Micro-Optical Components on Glass by Etching-Assisted Femtosecond Laser Modification

Transition-free indirect bonding towards 3D multi-layer glass stacking