Abstract:In order to offer higher average brightness and more stable photon beam, top-up injection mode is scheduled for daily operation in SSRF. Several critical beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely and reliably, and few interlock logics need to be added into machine protection system with top-up mode. Several hardware and software optimizations of beam instrumentation for this purpose will be introduced in this paper. OVERVIEW Shanghai Synchrotron Radiation Facility (SSRF) is a third generation light source, which located at Shanghai, P.R. China. Since December 2012, SSRF has operated in top-up mode for user experiments, which was a milestone of SSRF in facility performance improvements. The topup injections are made continuously at the time interval of about 10 minutes. Each injection cycle takes about 10 seconds and the bunch change uniformity of the 500 bunch train is better than 95%. For the top-up operation, several beam parameters, such as filling pattern, average current, beam lifetime and transfer efficiency, need to be measured precisely. Some extra interlock logics were added into machine protection system. This paper will introduce the details of hardware and software optimizations of beam instrumentation for the purpose above. FILLING PATTERN Bunch charge uniformity control is very important for the top-up operation. The quality mainly depends on the precision of bunch charge & filling pattern measurement. This measurement can be realized by direct sampling BPM pickup signal [1-3] or synchrotron radiation signal [4]. Due to easy configuration and good linearity button, BPM pickups and PXI waveform digitizer based solution have been adopted [5].

Two Fast Multiturn Injection Models for Synchrotron Injection Efficiency Optimization

Multiturn Injection Design and Optimization for XiPAF-Upgrading Synchrotron

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Optimization of the Multi-turn Injection Efficiency for Medical Synchrotron

Study on XiPAF-Upgrading Synchrotron Beam Loss

The Modeling of Time-Structured Multiturn Injection into Fermilab Main Injector (Microbunch Injection with Parasitic Longitudinal Painting)

Multiplexed Photoinjector Optimization for High-Repetition-Rate Free-Electron Lasers

Simulation Study of a Photo-Injector for Brightness Improvement in Thomson Scattering X-Ray Source Via Ballistic Bunching

Matched phase sweep method for the optimization of bunching factor in dual rf systems of high-intensity hadron synchrotrons

Optimization of the Compact Gamma-ray Source Based on Inverse Compton Scattering Design

Start-to-end Modeling and Transmission Efficiency Optimization for a Cyclotron-Based Proton Therapy Beamline

Study on the injection optimization and transverse coupling for CSNS/RCS

Conceptual design of injection system for Hefei Light source (HLS) upgrade project

Beam Dynamics Optimization of Very-High-frequency Gun Photoinjector

Synchrotron Injection and Acceleration Commissioning of Xi'an 200 MeV Proton Application Facility

Optimization of Low-Energy Slow Extraction Efficiency of XiPAF

The new progress in injector and positron source of STCF

A Simple Scheme for Injection and Extraction in Compact Rings.

Comparison of different longitudinal injection scenarios for achieving optimal performance in SAPS

The optimization for the conceptual design of a 300 MeV proton synchrotron

Advancing Electron Injection Dynamics and Mitigation Approaches in the Electron-Ion Collider Swap-out Injection Scheme