Abstract:We present, in this paper, the development progress of the 13MeV proton linac for the Compact Pulsed Hadron Source (CPHS), and the 7MeV Hlinac injector for the synchrotron of the Xi’an 200MeV Proton Application Facility (XiPAF). INTRODUCTION One proton and one Hlinear accelerators are being constructed. The Compact Pulsed Hadron Source (CPHS) project is aimed at becoming an experimental platform for education, research, and innovative applications at Tsinghua University. The facility will provide the proton beam, together with the neutron beam by delivering the proton beam to bombard the beryllium target. The designed parameters for the proton beam is 13 MeV/50 mA with the pulse length of 500 μs and repetition rate of 50 Hz [1][2]. The Xi’an 200MeV Proton Application Facility (XiPAF) project was launched in the year of 2014 for the research of the single event effect. The facility is mainly composed of one 7 MeV Hlinac injector, one 200 MeV six-fold synchrotron and two experimental stations. The designed parameters for the Hbeam of the linac injector is 7 MeV/5 mA with the pulse length of 10-40 μs and maximum repetition rate of 0.5 Hz [3]. 13 MeV PROTON LINAC FOR CPHS CPHS project consists of a high-current proton linac (13 MeV, 16 kW, peak current 50 mA, 0.5 ms pulse width at 50 Hz), a neutron target station, a small-angle neutron scattering instrument and a neutron imaging/radiology station. The accelerator system consists of the 50 keV ECR Ion Source (IS), Low Energy Beam Transport line (LEBT), 3MeV four-vane Radio Frequency Quadrupole (RFQ) accelerator, 13 MeV Alvarez-type Drift Tube Linac (DTL), RF power supply and distributor, and High Energy Beam Transport line (HEBT). Figure 1 presents the latest layout of the linac of the compact pulsed hadron source. Figure 1: Layout of the linac of the compact pulsed hadron source. CPHS has provided ~2000 hrs beam time since 2013 to the users with the neutrons produced by the 3 MeV proton beam from the RFQ bombarding on the beryllium target [4]. The application of the neutrons mainly consists of the neutron imaging [5], and the test of the neutron detectors including the B4C-coated straw-tube [6] and the gadolinium-doped micro-channel plate (MCP) [7]. DTL The 4.3-meter-long Alvarez-type DTL accelerates the 3 MeV proton beam to 13 MeV. The final tuning of the DTL cavity is completed and it is being installed in the beam line (Fig. 2). Figure 2: Assembled CPHS DTL for RF measurement. ____________________________________________ * Work supported by National Natural Science Foundation of China (Project 11575098 and 11275106). † wangxuewu@tsinghua.edu.cn 29th Linear Accelerator Conf. LINAC2018, Beijing, China JACoW Publishing ISBN: 978-3-95450-194-6 ISSN: 2226-0366 doi:10.18429/JACoW-LINAC2018-THPO022 THPO022 732 Co nt en tf ro m th is w or k m ay be us ed un de rt he te rm so ft he CC BY 3. 0 lic en ce (© 20 18 ). A ny di str ib ut io n of th is w or k m us tm ai nt ai n at tri bu tio n to th e au th or (s ), tit le of th e w or k, pu bl ish er ,a nd D O I. Proton and Ion Accelerators and Applications Proton linac projects Figures 3 and 4 illustrate the field distribution of the DTL cavity and the tilt sensitivity after the final tuning, respectively. The relative error of the field between the designed and measured distribution is within 1.6%, and the tilt sensitivity is tuned to be within ±33%/MHz in all cells. Figure 3: Field distribution of the CPHS DTL after the final tuning. Figure 4: Tilt sensitivity of the CPHS DTL after the final tuning. RF Power System The DTL will share with the RFQ the same klystron, which can supply the peak RF power of 3.0 MW with a maximum duty factor of 3.33%. The RF transmission system is being installed, as shown in Fig. 5. Figure 5: RF power system for the CPHS RFQ and DTL. 7 MeV HLINAC INJECTOR FOR XiPAF The 7 MeV Hlinac injector for the synchrotron of the XiPAF project is composed of the 50 keV HECR source, LEBT, 3 MeV four-vane RFQ accelerator, 7 MeV KONUS-IH-DTL, and the corresponding RF power source system. ECR Ion Source The Hsource has been assembled as in Fig. 6 and the maximum current of 5.8 mA has been measured by the Faraday cup at the exit of the source (Fig. 7). Figure 6: Assembled HECR source at site for XiPAF. Figure 7: Beam current measured by the Faraday cup at the exit of the Hsource. LEBT The LEBT will steer and match the beam from the ion source to the RFQ by two solenoids and two steering magnets. The LEBT has been assembled and is under beam conditioning (Fig. 8). Figure 8: Assembled XiPAF LEBT at site. 29th Linear Accelerator Conf. LINAC2018, Beijing, China JACoW Publishing ISBN: 978-3-95450-194-6 ISSN: 2226-0366 doi:10.18429/JACoW-LINAC2018-THPO022 Proton and Ion Accelerators and Applications Proton linac projects THPO022 733 Co nt en tf ro m th is w or k m ay be us ed un de rt he te rm so ft he CC BY 3. 0 lic en ce (© 20 18 ). A ny di str ib ut io n of th is w or k m us tm ai nt ai n at tri bu tio n to th e au th or (s ), tit le of th e w or k, pu bl ish er ,a nd D O I.

Synchrotron Injection and Acceleration Commissioning of Xi'an 200 MeV Proton Application Facility

Commissioning of the 7 MeV H<SUP>-</SUP> linac injector for a 200 MeV proton synchrotron

Construction and Beam Commissioning of a Compact Proton Synchrotron for Space Radiation Environment Simulation

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Design and Test of an RF Acceleration System Loaded with Magnetic Alloy for the Proton Synchrotron of the Xi’an Proton Application Facility

Beam instrumentation system development and commissioning in ssrf

High Intensity Proton Beam Transportation Through Fringe Field of 70 MeV Compact Cyclotron to Beam Line Targets

THE 230 MeV PROTON ACCELERATOR FOR XI ’ AN PROTON APPLICATION FACILITY

Beam instrumentation system for shanghai soft x-ray fel test facility*

Applications for Synchrotron Radiation in Inertial Confinement Fusion Research

Multiturn Injection Design and Optimization for XiPAF-Upgrading Synchrotron

Design of the 7mev Linac Injector for the 200mev Synchrotron of the Xi'an Proton Application Facility

Optimization of Low-Energy Slow Extraction Efficiency of XiPAF

Research on Longitudinal Dynamics and Design of RF Parameters of Synchrotron for XiPAF-upgrading Project

Study on XiPAF-Upgrading Synchrotron Beam Loss

The beam commissioning of a CW high charge state heavy ion RFQ

COMMISSIONING STATUS OF THE 3 MEV RFQ FOR THE COMPACT PULSED HADRON SOURCE ( CPHS ) AT TSINGHUA UNIVERSITY

A 60 MeV ultra-compact proton accelerator for proton radiation effects in China

The optimization for the conceptual design of a 300 MeV proton synchrotron

Closed-orbit Distortion Study of XiPAF Upgrading Project Synchrotron

Development Progress of the H⁺/H⁻ Linear Accelerators at Tsinghua University