Abstract:We present, in this paper, the design result of the 7 MeV linac which will inject the negative hydrogen ion beam to the downsteam synchrotron of the Xi`an Proton Application Facility (XiPAF). This newly designed facility will be located in Xi’an city and provide the proton beam with the maximum energy of 230 MeV for the research of the single event effect. The 7 MeV linac injector is composed of the 50 keV negative hydrogen ion source, Low Energy Beam Transport line (LEBT), 3 MeV four-vane type Radio Frequency Quadrupole (RFQ) accelerator, 7 MeV Alvarez-type Drift Tube Linac (DTL), and the corresponding RF power source system. The output beam of the linac injector is designed with the peak current of 5 mA, maximum repetition frequency of 0.5 Hz, beam pulse width of 10~40 s and RMS normalized emittance of 0.24 mm•mard. INTRODUCTION To fulfill the need of the experimental simulation of the space radiation environment, especially the investigation of the single event effect, the project of Xi`an Proton Application Facility (XiPAF) is under construction in Xi’an City, China. The facility is mainly composed of one 7 MeV H linac injector (Fig. 1), one Middle Energy Beam Transport line (MEBT), one 200 MeV six-fold synchrotron, two High Energy Beam Transport lines (HEBT) and two experimental stations. A flux of 10~10 p/cm/s with the non-uniformity of better than ±10% on the sample in the range of 1 cm×1 cm ~ 10 cm×10 cm is designed. The synchrotron will be operated with the slow-extraction mode to provide the proton beam with the pulse width of 1~10 s. The designed number of the accumulated protons in each pulse in the synchrotron is 1×10. Injection energy of 7 MeV is therefore determined to both achieve the accumulated particles in the synchrotron and limit the cost of the linac injector. The negative hydrogen ion beam is debunched to reduce the energy spread and strip-injected into the synchrotron. The parameter requirement of the linac injector is presented in Table 1. In this paper, the design result of the 7 MeV linac injector for the 230 MeV synchrotron of the XiPAF project is presented. Table 1: Requirement of the Linac Injector for XiPAF Parameter Value Unit

Optimization of Low-Energy Slow Extraction Efficiency of XiPAF

Multiple Energy Extraction Experiment at XiPAF Synchrotron

Study on XiPAF-Upgrading Synchrotron Beam Loss

High Intensity Proton Beam Transportation Through Fringe Field of 70 MeV Compact Cyclotron to Beam Line Targets

Investigation and Improvement of Spill Quality at XiPAF Synchrotron

Construction and Beam Commissioning of a Compact Proton Synchrotron for Space Radiation Environment Simulation

Optimization of Proton Beam Quality by Obliquely Incident Laser Pre-Pulse

THE 230 MeV PROTON ACCELERATOR FOR XI ’ AN PROTON APPLICATION FACILITY

Beam Instrumentation System Optimization for Top-up Operation in SSRF

Multiturn Injection Design and Optimization for XiPAF-Upgrading Synchrotron

Synchrotron Injection and Acceleration Commissioning of Xi'an 200 MeV Proton Application Facility

Design and Test of an RF Acceleration System Loaded with Magnetic Alloy for the Proton Synchrotron of the Xi’an Proton Application Facility

A 60 MeV ultra-compact proton accelerator for proton radiation effects in China

Research on Longitudinal Dynamics and Design of RF Parameters of Synchrotron for XiPAF-upgrading Project

Commissioning of the 7 MeV H<SUP>-</SUP> linac injector for a 200 MeV proton synchrotron

Design of the 7mev Linac Injector for the 200mev Synchrotron of the Xi'an Proton Application Facility

The optimization for the conceptual design of a 300 MeV proton synchrotron

Optimization of LANSCE Proton Beam Performance for Isotope Production

Study of Influence of Dipole and Quadrupole Power Ripple on Slow Extraction for XiPAF

Design of a Low-Energy Proton Facility for Space Radiation Effect Research Based on a Compact Neutron Source

Methods to obtain high intensity proton ion beams with low emittance from ECR ion source at Peking university