Abstract:Although defect engineering is the core strategy to improve thermoelectric properties, there are limited methods to effectively modulate the designed defects. Herein, we demonstrate that a high ZT value of 1.36 at 775 K and a high average ZT value of 0.99 in the temperature range from 300 to 825 K are realized in Zn-containing PbTe by designing complex defects. By combining first-principles calculations and experiments, we show that Zn atoms occupy both Pb sites and interstitial sites in PbTe and couple with each other. The contraction stress induced via substitutional Zn on Pb sites alleviates the swelling stress by Zn atoms occupying the interstitial sites and promotes the solubility of interstitial Zn atoms in the structure of PbTe. The stabilization of Zn impurity as a complex defect extends the region of PbTe phase stability toward Pb0.995Zn0.02Te, while the solid solution region in the other direction of the ternary phase diagram is much smaller. The evolution of defects in PbTe was further explicitly corroborated by aberration-corrected scanning transmission electron microscopy (Cs-corrected STEM) and positron annihilation measurement. The Zn atoms compensate the Pb vacancies (VPb) and Zn interstitials (Zni) significantly improve the electron concentration, producing a high carrier mobility of 1467.7 cm2 V–1 s–1 for the Pb0.995Zn0.02Te sample. A high power factor of 4.11 mW m–1 K–2 is achieved for the Pb0.995Zn0.02Te sample at 306 K. This work provides new insights into understanding the nature and evolution of the defects in n-type PbTe as well as improving the electronic and thermal transport properties toward higher thermoelectric performance.The Supporting Information is available free of charge at https://pubs.acs.org/doi/10.1021/acsami.1c14518.Experimental section, backscattering electron images, wavelength dispersive spectrometer results, electrical and thermal transport performance of the Pb1–yZnyTe samples, and room-temperature carrier mobility as a function of carrier concentration for the Pb1–yZn0.015+yTe samples and several n-type PbTe compounds (PDF)This article has not yet been cited by other publications.

High Defect Tolerance in Heavy‐Band Thermoelectrics

Zn-Induced Defect Complexity for the High Thermoelectric Performance of n-Type PbTe Compounds

Compositional Tailoring for Realizing High Thermoelectric Performance in Hafnium-Free n-Type ZrNiSn Half-Heusler Alloys

High Band Degeneracy Contributes to High Thermoelectric Performance in p-Type Half-Heusler Compounds

Functionally Separated Electronic Band Engineering Via Multi-Element Doping Plus High-Density Defects Advances Board-Temperature-range Thermoelectric Performance in GeTe

Improving thermoelectric properties of ZrPtSn-based half-Heusler compound by Sb doping

Selective Scatterings of Phonons and Electrons in Defective Half-Heusler Nb1-CoSb for the Figure of Merit Zt > 1

Selective Scatterings of Phonons and Electrons in Defective Half‐Heusler Nb1−δCoSb for the Figure of Merit zT > 1

Fine Tuning of Defects Enables High Carrier Mobility and Enhanced Thermoelectric Performance of N-Type PbTe

A New Defective 19-Electron TiPtSb Half-Heusler Thermoelectric Compound with Heavy Band and Low Lattice Thermal Conductivity

Realizing high figure of merit in heavy-band p -type half-Heusler thermoelectric materials

Manipulation of Band Structure and Interstitial Defects for Improving Thermoelectric SnTe

Deep defect level engineering: A strategy of optimizing the carrier concentration for high thermoelectric performance

Enhancing n-type PbTe thermoelectric performance through Cd alloying and strategic defects management

Modulation of Vacancy Defects and Texture for High Performance N-Type Bi2 Te3 Via High Energy Refinement.

Enhanced Thermoelectric Performance in the N-Type NbFeSb Half-Heusler Compound with Heavy Element Ir Doping

Engineering the Thermoelectric Transport in Half‐Heusler Materials through a Bottom‐Up Nanostructure Synthesis

High thermoelectric performance in ZrNiSn through electron injection and boosting carrier mobility

High-Ranged <i>ZT</i> Value Promotes Thermoelectric Cooling and Power Generation in n-Type PbTe

Band engineering of high performance p-type FeNbSb based half-Heusler thermoelectric materials for figure of merit zT > 1

Improved High‐Temperature Material Stability and Mechanical Properties While Maintaining a High Figure of Merit in Nanostructured p‐Type PbTe‐Based Thermoelectric Elements