Abstract:Using high purity oxide (MgO, Al2O3 and SiO2) as raw materials, porous cordierite ceramics with a single phase and adjustable pore structure have been in-situ synthesized by foam gel-casting process. The effects of sintering temperature and foaming agent concentration on the phase composition, microstructure and properties were systematically investigated. The results indicated that pure cordierite could be obtained at sintering temperatures of 1430 degrees C and 1450 degrees C, while the sample sintered at 1450 degrees C showed better comprehensive performance. By adjusting the foaming agent concentration in the range of 2-32 g/L, the pore size of the materials could be controlled between 45.3 mu m and 151.3 mu m with the total porosity of 85.4-87.8%. When the sintering temperature was 1450 degrees C and the foaming agent concentration was 8 g/L, the prepared samples showed excellent properties and the near net size sintering was achieved. The sintering linear shrinkage was about 0.26%, the total porosity was 86.6 +/- 0.2%, the bulk density was 0.35 +/- 0.01 g/cm(3), the compressive strength was 2.63 +/- 0.33 MPa, the thermal conductivity was 0.217 +/- 0.026 W/(m.K), the thermal expansion coefficient was 1.70 x 10(-6)/degrees C, and the permeability of deionized water was 3.62 x 10(-11) m(2).

Nearly dense cordierite bonded silicon carbide ceramics prepared by hot pressing sintering at 1650°C

Fabrication and Properties of Cordierite–mullite Bonded Porous SiC Ceramics

Fabrication and Properties of Porous Sic-Cordierite Ceramics

Study on the Performance for Silicon Carbide Ceramics by Hot-pressing Sintering

Effects of SiC contents on the microstructure and mechanical properties of Al4SiC4–SiC ceramic composites

Mechanical and microstructural properties of cordierite-bonded porous SiC ceramics processed by infiltration technique using various pore formers

Hot pressed SiC ceramics employing polymer-derived SiBCN as sintering aid

Dielectric constant, dielectric loss and thermal conductivity of Si3N4 ceramics by hot pressing with CeO2–MgO as sintering aid

Microstructure and mechanical properties of spark plasma sintered SiC ceramics aided by B4C

A simple method for the preparation of cordierite ceramics with high strength and low thermal expansion coefficient

In-situ synthesis and properties of porous cordierite ceramics with adjustable pore structure

Preparation and Mechanical Properties of ZrB2-based Ceramics Using MoSi2 As Sintering Aids

Preparation and properties of zirconium diboride-based ultra-high temperature ceramics

Microstructure and Mechanical Properties of Hot-Pressed Al2O3–mullite–ZrO2–SiC Composites

Fabrication and Property of SiC Ceramic with Large Thickness/Diameter Ratios

Novel (Zr, Ti)(C, N)–SiC ceramics via reactive hot-pressing at low temperature

Pressureless Sintering of Silicon Carbide Ceramics Containing Zirconium Diboride

Novel TiC-based ceramic with enhanced mechanical properties by reaction hot-pressing at low temperature

Effect of sintering temperature and holding time on the microstructure and mechanical properties of ZrB2–SiCw composites

Preparation of high-purity SiC ceramics with good plasma corrosion resistance by hot-pressing sintering

Fabrication and Characterization of Porous Cordierite Ceramics Prepared from Fly Ash and Natural Minerals