Abstract:Rock is the main construction material of rock engineering, such as the engineering of mines and tunnels; in addition, its mechanical properties and failure laws are of great significance to the stability evaluation of rock engineering, especially under the conditions of coupled static-static stresses. In this study, granite specimens were manufactured with artificial flaws. Coupled static and dynamic loads tests were carried out with a modified split Hopkinson pressure bar (SHPB) apparatus; and six typical levels of axial pre-stresses and three crack inclination angles were designed. Three-dimensional digital image correlation (3D-DIC) was also applied to record and analyze the fracturing process and damage evolution of the specimens. The test results show that there was no compaction stage in the stress-strain curve under combined dynamic and static loading. The dynamic strength of the specimens increased first and then decreased with the increase in the static pressure; moreover, the specimens reached the maximum dynamic strength when the static pressure was 10% UCS. The dynamic strength decreased first and then increased with the increase in the crack inclination angle; and the lowest strength appeared when the inclination angle was 45°. The change in axial compression had a significant influence on the failure mode, and the failure mode gradually transformed from shear-tensile failure to shear failure with the increase in the pre-stress. The tensile strain was usually generated at the end of the fractures or near the rock bridge. When the axial pressure was small, the tensile strain zone parallel to the loading direction was easily generated; and when the axial pressure was large, a shear strain zone developed, extending along the diagonal direction. The research results can provide a theoretical reference for the correct understanding of the failure mechanisms of granite and its engineering stability under actual conditions.

Strength Characteristics and Double-Yield Elastoplastic Constitutive Model of Granite

Uniaxial Compressive Behavior of Granite at High Strain Rates

Mechanical Behavior of a Granite from Wuyi Mountain: Insights from Strain-Based Approaches

A coupled strain softening and hardening model for completely weathered granite in a fault zone

An improved strain-softening constitutive model of granite considering the effect of crack deformation

Study on the Constitutive Model and the Identification of Parameters of Granite Based on the Crack Closure Ratio

Dynamic Mechanical Properties and Damage Evolution Characteristics of Beishan Deep Granite under Medium and High Strain Rates

Characterization and constitutive modeling of the high strain rate behavior of granite at low temperatures

Experimental Study on Mechanical Properties and Failure Laws of Granite with Artificial Flaws under Coupled Static and Dynamic Loads

Effect of confining pressure on deformation and strength of granite in confined direct tension tests

Experimental Investigation of Nonlinear Energy Evolution and Failure Characteristics of Granite under Different Water Content States

Strength and Failure Properties of Preflawed Granite under Coupled Biaxial Loading and Unloading Conditions

Strain-softening model for granite and sandstone based on experimental and discrete element methods

Characteristics of strain softening of rocks and its damage constitutive model

Experimental Investigation and Semi-Analytical Simulation of Instantaneous and Time-Dependent Damage Behaviors of Beishan Granite

Dynamic Properties and Dynamic Response Model of Jointed Granites by Cyclic Loading

Undrained mechanical behavior of saturated completely decomposed granite: experimental investigation and constitutive modeling

Energy Storage Characteristics and Damage Constitutive Model of Thermally Treated Granite: an Experimental Investigation

Experimental research on the mechanical properties and energy transfer of fractured granite under triaxial loading

Experimental and GBM3D study on the failure mechanical behavior of granite with different grain sizes under conventional triaxial compression

Research on the Impact Mechanical Properties of Real-Time High-Temperature Granite and a Coupled Thermal-Mechanical Constitutive Model