Raw Material Design, Sintering Temperature Optimization and Development Mechanism Investigation of Self-Foaming Porous Bricks with High Solid Waste Addition

Laihao Yu,Xin Shen,Yingyi Zhang,Hanlei Liu,Chunyin Zhang,Zhichen Han
DOI: https://doi.org/10.1016/j.cej.2024.153711
IF: 15.1
2024-01-01
Chemical Engineering Journal
Abstract:In recent years, the contradiction between the huge production of municipal sludge and industrial residue and the shortage of landfill space has driven the exploration of novel effective methods to valorize these solid wastes. In this research, blast furnace slag (BFS), municipal sewage sludge (MSS) and kaolin are combined innovatively as precursor materials to manufacture self-foaming porous bricks, and the sintering behavior of bricks under different BFS doses and sintering temperatures is deeply studied to reveal the development mechanism. The results indicate that the formation of Fe 2 O 3-hematite during sintering leads to a reddish-brown appearance of the bricks, while the generation of CaAl 2 Si 2 O 8-anorthite with lower melting points helps to enhance the vitrification process. Besides, the increase in BFS dose or sintering temperature has significant impacts on the evolution of the brick physicochemical properties. This occurs because changing the dose of BFS or sintering temperature can obviously regulate the internal morphological characteristics of bricks, such as particle consolidation, pore size and structural compactness. Among them, large-sized pores are considered as the weak areas of mechanical strength, which is also the responsibility for the worst compressive strength of bricks sintered at 1300 degrees C. Finally, under the optimal sintering conditions of 15 % BFS dose and 1250 degrees C sintering temperature, the compressive strength, water absorption, apparent porosity, bulk density and linear shrinkage of the resulting brick are 65 MPa, 0.45 %, 2.50 %, 2.34 g/cm 3 and 19.56 %, respectively. Overall results demonstrate that using recycled sludge and waste slag in brick manufacturing can produce products with desired performance, providing preferable solutions for solid waste valorization and sustainable brick production.
What problem does this paper attempt to address?