Preparation and Patterning of HfO 2 Film Via Sol - Gel Method and Resistive Switching Effect of Pt/HfO 2 /lanio 3

Xiaoqin Liu,Jianbo Liu,Wei Li,Qingqing Sheng,Yeming He,Yangyang Wang
DOI: https://doi.org/10.1016/j.mssp.2024.108463
IF: 4.1
2024-01-01
Materials Science in Semiconductor Processing
Abstract:Sol-gel method is a low-cost material preparation method; however, it is difficult to obtain a stable sol containing easily hydrolyzable metal ions via this method. In this study, a stable hafnium(IV) oxide (HfO 2 ) sol was prepared by adding benzoyl acetone (BzAcH) modifier. Infrared absorption spectroscopy results showed that the BzAcH additive chelated with the Hf 4+ ions in the sol, thus improving the hydrolysis resistance of the HfO 2 sol, which in turn improved its stability. It was also found that the BzAcH-modified HfO 2 gel film exhibited ultraviolet (UV) photosensitivity. After UV exposure, the film did not dissolve easily in organic solvents. Based on these properties, the micro processing of the HfO 2 film was preliminarily explored, and HfO 2 microstructures were successfully obtained. Additionally, the relative permittivity ( epsilon r ) of HfO 2 exhibited minimum (-10.9) and maximum (-20.6) values at heat -treatment (HT) temperatures of 350 and 450 degrees C, respectively. With the continuous increase in the HT temperature, epsilon r first decreased and then increased slightly. Moreover, the current-voltage curves showed that the Pt/HfO 2 /LaNiO 3 (LNO) structure exhibited a pronounced bipolar resistive switching (RS) effect, which was attributed to the fact that LNO could be used as an electrode and an oxygen vacancy (OV 2+ ) storage layer for RS materials. Notably, the oxygen ions in HfO 2 with a low degree of crystallinity are more likely to migrate within its body (which makes it easier to form OV 2+ s), therefore, the "Set" voltage of low -crystallinity HfO 2 films is lower than that of high -crystallinity HfO 2 films. The RS mechanism can be explained by the OV 2+ conductive filament model. These results are of great practical significance for the low-cost preparation of HfO 2 and the application of LNO as an oxide electrode.
What problem does this paper attempt to address?