Abstract:The Raman shift of the nu(3)(SiO4) mode of zircon at -1008 cm(-1) has been observed to vary with the pressure (P) and temperature (7) of the environment. The relationship between the nu(3)(SiO4) peak position and P-T was calibrated in previous work and used to develop a pressure sensor for high P-T experiments, up to 1000 degrees C and 10 GPa, to an accuracy within +/- 50 MPa. This pressure measurement method is valid for zircon grains for which the nu(3)(SiO4) Raman shift occurs specifically at or close to 1008.17 cm(-1) at room temperature (25 degrees C). However, the peak position of nu(3)(SiO4) for some zircon grains may shift to a lower or higher wavenumber under ambient conditions, mainly due to the chemical composition of the grains. This may cause substantial deviation in the measured pressures. In the present study, we recalibrated the pressure sensor by determining the position of the nu(3)(SiO4) peak for zircon grains with different chemical compositions at given P-T conditions and developed a model applicable to both natural and synthetic zircon samples. All the zircon samples considered were found to have a universal nu-T relationship when the nu(3)(SiO4) wavenumbers under ambient conditions were calibrated to the same position. Based on this relationship, the temperature-induced wavenumber shift of nu(3)(SiO4) can be expressed as Delta nu(T) (cm(-1)) = 8.00 x 10(-9) x (T-3 - T-o(3))- 2.00 x 10(-5) x (T2 - T-o(2))- 2.78 x 10(-2) x (T - T-o), where T and T-0 are the target and room temperatures, respectively. In addition, the pressure-induced wavenumber shift of nu(3)(SiO4) can be calculated using Delta nu(P) (cm(-1)) = Delta nu - Delta nu(T), where Av is the total frequency shift between the target and ambient P-T conditions. By the linear regression of the experimental results, the global slope (partial derivative nu/partial derivative P)(T) was determined to be 5.91 x 10(-3) cm(-1)/MPa. In addition, high P-T experiments performed in isochoric systems using a hydrothermal diamond anvil cell (HDAC) showed that the cross-derivative term (partial derivative(2)nu/partial derivative P partial derivative T) was equal to zero, which is the same as the previous study. The revised method was used to determine the pressures inside a fused silica capillary capsule (FSCC) containing a NaCl solution. The pressures determined from the zircon Raman spectra (P-zr) were compared with those calculated using the equation of state (P-Eos) of a NaCl-H2O system. The determined P-Zr and P-Eos values agreed well for temperatures lower than similar to 500 degrees C. However, P. was significantly lower than P-Eos at higher temperatures due to the thermal expansion of the FSCC, i.e., the expansion of the sample chamber under the high internal pressures when the silica glass softened at high temperatures. The revised method was programmed in a Microsoft EXCEL spreadsheet and is presented in the Appendix B.

Time‐resolved Raman Spectroscopy Study of Rapid Compressed Silicon and Its Potential As a Raman Pressure Scale in a Dynamic Diamond Anvil Cell

Time-resolved Raman spectroscopy for monitoring the structural evolution of materials during rapid compression

Elastic Property of SiC-Diamond Composite under Hydrostatic Pressure

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

Atomistic deformation mechanism of silicon under laser-driven shock compression

Internal Stress‐Related Vibrational Splitting in Compressed SiO2

Compression Rate of Dynamic Diamond Anvil Cells from Room Temperature to 10 K

In-situ Raman study and phase transition of gypsum under high pressure

High‐pressure and high‐temperature Raman spectroscopic study of zircon as a pressure scale in hydrothermal DACs

Millisecond time-resolved synchrotron radiation X-ray diffraction and high pressure rapid compression device and its application

Raman Scattering from Highly-Stressed Anvil Diamond

Measurement of Stress in Diamond Anvils with Micro‐raman Spectroscopy

Extreme static compression of carbon to terapascal pressures

Recovery of Si-IV nanowires from extreme GPa pressure

Shock Compression of Diamonds in Silicon Carbide Matrix Up to 110 GPa

Equation of State, Stability, Anisotropy and Nonlinear Elasticity of Diamond-Cubic (ZB) Silicon by Phonon Imaging at High Pressure

Micro-Raman spectroscopy of ultrashort laser induced microexplosion sites in silicon

Study on shock compression phase transition of single crystal silicon based on molecular dynamics simulation

Reassessment of the Zircon Raman Spectroscopic Pressure Sensor and Application to Pressure Determination of Fused Silica Capillary Capsule

Synchrotron X-Ray Diffraction of Sio2 to Multimegabar Pressures

The moissanite anvil cell: a new tool for high-pressure research