Abstract:The motivation of the present study is to gain insights into the evolution of elastic properties of cemented tungsten carbides (WC) shock compressed to 100 GPa. Seven plate impact experiments—two front surface impact and five release wave overtake—are conducted to make simultaneous measurements of Hugoniot states and longitudinal sound speeds in shocked WC with 3.7wt.% cobalt binder. The sound speeds along with estimates for bulk sound speeds, obtained using the Birch–Murnaghan EoS, are analyzed to determine the elastic moduli—longitudinal, bulk, and shear—as a function of Hugoniot stress. The longitudinal and bulk sound speeds at Hugoniot states of interest are found to increase linearly with longitudinal stress. Consistent with the increase in sound speeds, the longitudinal and bulk moduli also increase with Hugoniot stress; however, the increase in longitudinal modulus is modest when compared to predictions of theoretical models that account for pressure and temperature dependence of elastic moduli, but with no damage. The shear moduli remain nearly constant at ∼318 GPa over the range of Hugoniot states investigated. These values are, however, much lower than those predicted by the Steinberg–Guinan model with no damage. Poisson’s ratio decreases initially from its ambient value of 0.208 to ∼0.199 for Hugoniot stress ≤10 GPa indicating consolidation of the WC microstructure with low initial stress; however, with an increase in Hugoniot stress to ∼100 GPa, Poisson’s ratio increases to ∼0.317, indicating degradation of shear moduli with increasing stress. The product of density and Grüneisen parameter (ρΓ), after an initial spike, remains nearly constant for volumetric strains ≥0.07. The maximum average temperature rise is estimated to be ∼286°C at the highest Hugoniot stress employed in the study.

Elastic Property of SiC-Diamond Composite under Hydrostatic Pressure

Ultrasound Elasticity of Diamond at Gigapascal Pressures

First-Principle Calculations for Elastic and Thermodynamic Properties of Diamond

First-Principles Calculations for Elastic Properties of ZnS under Pressure

Hardness And Elastic Moduli Of High Pressure Synthesized Mob2 And Wb2 Compacts

Effect of Hexagonality on the Pressure-Dependent Lattice Dynamics of 4H-Sic

Elastic Properties Of Single Crystal Hydrogen Sulfide: A Brillouin Scattering Study Under High Pressure-Temperature

Physical Properties and Mechanical Behavior of WSi2 at High Pressure

Velocity and Stability of Condensed Polymorphic SiH4: A High-Temperature High-Pressure Brillouin Investigation*

Anisotropy in Elasticity and Physical Properties of Ti2B under High Pressure

Effect of diamond content on microstructure and properties of C/SiC-diamond composites

Examination of the Atomic Pair Distribution Function (PDF) of SiC Nanocrystals by In-situ High Pressure Diffraction

Sound speed measurements in shock compressed cemented tungsten carbide: Evolution of elastic moduli with damage at pressures to 100 GPa

The Thermal Expansion Behaviour of SiCp/Al–20Si Composites Solidified under High Pressures

Effect of pressure on sintering behavior of polycrystalline diamond

Lack of the Critical Pressure for Weakening of Size-Induced Stiffness in 3c–sic Nanocrystals under Hydrostatic Compression

Theoretical prediction of structural, elastic and thermodynamic properties of transition metal monosilicides CrSi, TiSi and ZrSi under high pressure

Dynamic response of Ti3SiC2 under shock compression up to 112 GPa

Nano-Diamond Compressibility at Pressures Up to 85 GPa

Cubic silicon carbide under tensile pressure: Spinodal instability

First-Principles Investigation of Elastic and Thermodynamic Properties of Sicn under Pressure