Abstract:In a switchgear, an external transverse magnetic field (ETMF) is generated by the U type loop consisting of the vacuum interrupter, external busbar and conductive rod connected to the vacuum interrupter. The ETMF will make the vacuum arc deflected and strengthen the contraction of the arc. This can increase the probability of breaking failure. To weaken the adverse effect of the ETMF, the real magnetic field data of the arc area with different structure parameters when the length of conductive rod, external busbar and phase distance is changed are obtained by establishing simulation model in this paper. Taking the real magnetic field data as the boundary condition, this paper obtains the typical parameters of the vacuum arc plasma with different structure parameters by using the established three-dimensional high-current vacuum arc magnetohydrodynamics model. The simulation results show that the ETMF makes the transverse magnetic field (TMF) of the arc area asymmetric, which leads to an arc deflection. Reducing the length of the conductive rod connected to the vacuum interrupter to 50 mm can effectively improve the asymmetry of the TMF caused by the EMTF, weaken the arc deflection phenomenon, make the distribution of the plasma parameters more uniform, and increases the utilization of the anode contact surface. Moreover, it can not only reduce the heat flux density into the anode as a whole, but also reduce the heat flux density in the high heat flux density area, so as to effectively reduce the degree of anode activity and improve the negative effects caused by the anode activity. The changes of other external structural parameters have less influence on the improvement of the vacuum arc deflection phenomenon. Increasing the phase spacing to 275 mm or reducing the length of the external bus bar to 100 mm can only slightly weaken the arc deflection.

Study on the Effect of Metal Vapor on the Post-Arc Process in Vacuum Arc with High Di/dt Condition

Study on the Dynamic Characteristics of Plasma in the Post-arc Process of Vacuum Arc Interrupting

Experiment Research Of Post-Arc Current And Cathode Spots Distribution In Medium-High Frequency Vacuum Arc

Experimental Research of Post-Arc Currents in Vacuum Circuit Breakers

The Effect and Dynamic Behavior of Particles in High-Current Vacuum Arc Interruptions

Study on the Proportions of Charged Particles Absorbed by Post-Arc Anode in the Post-Arc Phase of a Vacuum Circuit Breaker

Experimental Investigation on the Postarc Current in Vacuum Circuit Breakers and the Influence of Arcing Memory Effect

Experimental Study on Spatial and Temporal Distribution of Metal Vapor Atoms in High-Current Vacuum Arc

Investigation of Vacuum Arc Extinction Process by Planar Laser-Induced Fluorescence

Investigation of the Dielectric Recovery Process of Vacuum Arc in Double Breaks by Planar Laser-Induced Fluorescence

Experimental Investigation on the Velocity of Cathode Spots in a Vacuum Arc with High Di/dt

Experimental Investigation on Vacuum Arc Behaviors Subjected to Larger Diameter Cup-Shaped and Coil-Shaped Axial Magnetic Field Electrode

Experimental Investigations on the Post-Arc Current of the Vacuum Circuit Breaker in an Active Mechanical DC Circuit Breaker

The Effect of Contact Material on Particles Behavior in High-Current Vacuum Arcs

Two-Dimensional Particle-in-Cell/Monte Carlo Collisional Simulation of the Post-Arc Breakdown in Vacuum Circuit Breakers

Research on the current-zero period of vacuum arc interruption and equivalent model of post-arc gap

Experimental Study on Arcing Process of Vacuum Arc under Wan-Type Contacts

Numerical Investigation on the Influence of Circuit Breaker Structure Parameters on Vacuum Arc Behaviors

Experimental Investigation of High-Current Vacuum Arc Instability Modes under Transverse Magnetic Field

Study of vacuum arc plasma transport characteristics during the DC interrupting process

Experimental Investigation of Vacuum Arc under Different Axial Magnetic Field Contacts for 40.5 Kv Vacuum Interrupters