Abstract:Fillet welds by intermittent welding are widely used in the welding of centrifugal fans, such as attaching a fan blade to the rear plate. The intermittent welding method transforms the full-length continuous weld into multiple short welds to minimize distortion by reducing the total heat input for a welded joint to control welding distortion. An infinite number of short welds are created during this process. However, depending on the complexity of the model, the computational cost of predicting welding distortion based on full-scale modeling is considerable. These numerous short welds undoubtedly complicate modeling and computations, limiting rapid distortion prediction for large and complex structures. This study develops an equivalent deformation calculation approach based on a local-to-global technique and applies it to predict distortion of a fillet joint welded specimen. The approach consists of two steps. First, the welding-induced structural deformation is calculated for a two-dimensional (2D) weld and a 2D heat-affected zone (local calculation). Second, the 2D structural deformation is applied to the full-scale welded structure using a nearest-point spatial interpolation algorithm to acquire the three-dimensional (3D) equivalent deformation (global calculation). Note that the weld shape was considered in both local and global calculations. In addition, welding tests were performed, and the coordinates of the key points were measured. The geometric parameters of the welds used in the numerical simulations were obtained from experimental observations. Finally, the key point coordinates obtained by the proposed approach were compared with experimental measurements. Furthermore, the distribution of out-of-plane distortion caused by the new approach was compared with the simulation results of the thermo-elastic-plastic method performed on a full-scale welded structure. The proposed approach can be verified by both comparisons.

Estimating Welding Deformation of Ultra-Thin Mild Steel Bead-on-plate Joints by Means of Inherent Strain Method

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Prediction of Double-Sided Arc Welding Deformation Based on Dynamic Heat Distribution Model and TEP-FE Approach

Investigating Welding Distortion of Thin-Plate Stiffened Panel Steel Structures by Means of Thermal Elastic Plastic Finite Element Method

Numerical Prediction and Control of Deformation and Residual Stress in Double-Sided Arc Welding of Large Pressure Hull

Simulation and prediction for welding deformation on welding procedure of hand pallet truck

Study on the Prediction of Welding Distortion of Aluminium Alloy Based on Inherent Strain Method

Review on finite element analysis of welding deformation and residual stress

Thermal-Elastic-Plastic Finite Element Analysis for Laser Welding Deformation of Thin Plate

Study on FEM Numerical Simulation Method for the Welding Distortion

Welding-induced stresses and distortion in high-strength steel T-joints: Numerical and experimental study

Analysis of influence of initial gap of laser-arc hybrid butt welds on inherent strain and welding deformation of a pipe structure

Nonlinear Computational Welding Mechanics for Large Structures

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Finite Element Analysis of Residual Welding Stresses and Deformation for a 5A06 Aluminum Alloy Plate

Influence of Initial Structural Dimensions of Plates on Welding Distortion

3D-FEM numerical simulation of welding stress in thin aluminum alloy plate

Accuracy of computational welding mechanics methods for estimation of angular distortion and residual stresses

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Finite Element Prediction of Residual Stress and Deformation Induced by Double-Pass TIG Welding of Al 2219 Plate