Abstract:In operation, residual stresses will superimpose with load stresses affecting service life of welded constructions. Therefore, knowledge of the exact residual stress state is of great interest already in the design state. Experimental determination of residual stresses is possible using destructive and non-destructive methods. Especially for larger structures and small batch sizes destructive measuring techniques can be neglected. Non-destructive methods, however, do have process-specific disadvantages such as the limited resolution. Furthermore, residual stress gradients in the direction of sheet thickness cannot be determined. An alternative approach would be the virtualization of the design using the finite element method (FEM). The application of FEM gives an insight into residual stresses at each point of the computed model, in particular at areas which are not accessible to measurement. However, the use of the FEM for residual stress calculation is subject to certain limits and error sources due to the fine discretization and the high degree of non-linearity. In particular, the calculation of multi-layer welds will reach high computation times, even with high available computing capacities. Therefore, the calculation's practical benefit is hardly recognizable. This known issue is often counteracted with radical simplification of the welding task to be calculated. Simplification approaches such as reduction of layer numbers or semi-transient calculations result in manageable computing times, but can also lead to result accuracies, the quality of which must be questioned. This led to the following questioning. Which simplification strategies are applicable in numerical welding simulation in order to achieve acceptable accuracy by means of an application-oriented manner? For this purpose, reference models were produced that were experimentally verified. On this basis, simplification approaches were investigated numerically and their effects on result quality were quantified. It could be shown that most of the commonly used simplification approaches for the calculation of residual stresses and distortions are only partially permissible, if any.

Accuracy of computational welding mechanics methods for estimation of angular distortion and residual stresses

Assessing the Residual Stresses in Dissimilar Welded Joint: Depth-Sensing Indentation Testing and Numerical Simulation

Welding-induced stresses and distortion in high-strength steel T-joints: Numerical and experimental study

Study on FEM Numerical Simulation Method for the Welding Distortion

Accurate evaluation on residual stress considering solid-state phase transformation and initial stress in thick weld

Study on the Prediction of Welding Distortion of Aluminium Alloy Based on Inherent Strain Method

Numerical Simulation of Welding for Residual Stress Prediction of Low Carbon Steel

Simplified residual stress and distortion calculations of multi-pass welds and their possible influence on result quality

Recent Advances in the Prediction of Weld Residual Stress and Distortion - Part 1

Prediction of distortion in a thin-plate structure with intermittent fillet joints using a local-to-global approach

Sensitivity Analysis of Some High Efficiency Computational Methods for Welding Process Numerical Simulation

Electromagnetic Ultrasonic Measurement for Welding Residual Stress Detection - Comparison Between Experiment with Numerical Simulation

A novel approach to prediction of welding residual stress and distortion

Multiphysics Study of Thermal Profiles and Residual Stress in Welding

Numerical Simulation of the Stress-Strain State of a PAW-MIG-Welded 1561 Aluminum Alloy Butt Joint Produced Under Different Process Modes

FE analysis of residual stress and welding deformation of a low-alloy UHS quenched steel fillet joint

Investigation of Residual Stress in Butt-Welded Plates Considering Phase Transformation

Finite element analysis of the angular distortion and residual stress in underwater wet welding

Stress and distortion of the 10 mm thick plate EH40 and 316L different butt joints in 10 kW laser welding

The Different Welding Layers and Heat Source Energy on Residual Stresses in Swing Arc Narrow Gap MAG Welding

A physically consistent 2D residual stress model for approximating 3D effects in welding