Abstract:The silicon surface texturing is an essential part for the fabrication of crystalline silicon solar cells to increase the conversion efficiency. By adjusting the etching texturing condition, inverted pyramid (IP) and upright pyramid (UP) texturization were prepared on crystalline silicon substrates for fabrication of PERC solar cells. The surface morphology not only affects the light trapping but also impacts electrode shading loss and front electrode contact interface. The IP texturization presents better anti-reflective performance due to more common light paths and narrower silver grids owing to less flow of Ag paste on concave blocked structure, both of which results in the higher short-circuit current density (J sc ). Yet in terms of front Ag/Si contact interface, the IP texturization causes more Ag crystallites and more surface recombination under the present condition suitable for UP texturization because of more edges on the upper part of IP, which leads to the lower open-circuit voltage (V oc ). The final conversion efficiency of IP solar cells (23.61 %) is 0.06 % higher than that of UP solar cells (23.55 %). An improvement about 0.07 mA/cm 2 of J sc was achieved with IP samples and V oc has a decrease of 0.3 mV caused by the surface recombination on IP texturization. In summary, the structural characteristics of IP results in lower reflectivity and less electrode shading, while Ag/Si contact interface could be optimized by adjusting the processing condition, ultimately promising the higher efficiency.

Effect of Nucleating Agents on Crystalline Silicon Textured Structure: from Upright Pyramid to Analogous Inverted Pyramid

Influence of Inverted Pyramid Texturization on Front Metallization and Performance of Crystalline Silicon Solar Cells

Improvement of conversion efficiency of multicrystalline silicon solar cells by incorporating reactive ion etching texturing

Insights into Nucleation Engineering in Si Pyramidal Texturing for High Performance Heterojunction Solar Cells Applications

Chain pyramid texturization for better light trapping and efficiency of silicon solar cells

Investigations Of Random Pyramid Texture On The Surface Of Single-Crystalline Silicon For Solar Cells

Formation of Various Pyramidal Structures on Monocrystalline Silicon Surface and Their Influence on the Solar Cells

Fabrication of Multi-Crystalline Silicon Pyramid Structure and Improvement in Its Photovoltaic Performance

Nano-Texturing of Single Crystalline Silicon Via Cu-Catalyzed Chemical Etching

Ultrafast Random‐Pyramid Texturing for Efficient Monocrystalline Silicon Solar Cells

Texturing of Crystalline Si Thin Film Solar Cells Via Nanostructure to Boost Efficiency

Controllable Nanoscale Inverted Pyramids for Highly Efficient Quasi-Omnidirectional Crystalline Silicon Solar Cells.

Orthogonal Experimental Optimization of Surface Texturization of Monocrystalline Silicon for Solar Cell

Improved optical absorption in visible wavelength range for silicon solar cells via texturing with nanopyramid arrays.

Modification of Surface Morphology of A Textured Silicon Substrate and Its Application in Heterojunction Solar Cells

The Influence of the Pyramidal Texture Uniformity and Process Optimization on Monocrystalline Silicon Solar Cells

Constructing Submicron Textures on Mc-Si Solar Cells Via Copper-Catalyzed Chemical Etching

Upright Pyramids Vs. Inverted Pyramids Surface Textures: a Comparative Investigation on the Electrical Properties of PERC Solar Cells

Formation of Nanostructured Emitter for Silicon Solar Cells Using Catalytic Silver Nanoparticles

The Modulation of Surface Texture for Single-Crystalline Si Solar Cells Using Calibrated Silver Nanoparticles As a Catalyst

Pyramidal texturing of silicon surface via inorganic–organic hybrid alkaline liquor for heterojunction solar cells