Abstract:A super high-head Francis turbine with a gross head of nearly 700 m was designed with computational fluid dynamics (CFD) simulation and laboratory tests. Reduced-scale (1:3.7) physical and numerical models of the real-scale prototype were created to investigate the hydraulic performance. According to the CFD analysis, a strong rotor–stator interaction (RSI) between guide vanes and runner blades is observed as a result of the high-speed tangential flow towards runner created by the super high water head as well as the small gaps between the radial blades. At the designed best efficiency point (BEP), there is no significant flow recirculation inside the flow passage and minor loss occurs at the trailing edge of the stay vanes and guide vanes. Maximum velocity is observed at runner inlets due to flow acceleration through the narrow passages between the guide vanes. The elbow-shaped draft tube gradually decreases the flow velocity to keep the kinetic energy loss at a minimum. The laboratory test was conducted on a reduced-scale physical model to investigate the pressure pulsations and guide vane torque (GVT) under variable-discharge configurations, which are key concerns in the design of a high head turbine. Pressure sensor networks were installed at the inlet pipe, vaneless space and draft tube, respectively. The most intense pressure variation occurs at the inlet pipe and elbow at 0.04–0.2 GVOBEP and 1.5–1.8 GVOBEP with a low frequency about 0.3 times of the runner frequency, while the vibration in vaneless zone performs stable with the blade passing frequency caused by RSI. The GVT shows a declining trend and then keeps stable as GVOs increases at synchronized condition. For the misaligned conditions, the torque of adjacent guide vanes differs a lot except at the synchronous angle and maximum absolute value at least doubles than the synchronized condition.

Evaluation of the prototype performance of Wanjiazhai Francis turbine with flow pattern analysis

Experimental Flow Performance Investigation of Francis Turbines from Model to Prototype

Analysis of Energy Dissipation in Allowable, Restricted and Prohibited Operating Areas of Wanjiazhai Francis Turbine

Investigating the Performance of a Super High-head Francis Turbine under Variable Discharge Conditions Using Numerical and Experimental Approach

Transient Flow Dynamics Analysis of a Large Prototype Francis Turbine at Different Loads

Effects of Head and Discharge on Internal Flow Characteristics of a High-Quality Installed 1 GW Francis Turbine

Study on influence of the construction change of the spiral casing and draft tube on the flow loss in low head Francis turbine

Turbulence simulation and experimental study on new 3D wicket gate of francis turbine

EXPERIMENTAL AND CFD SIMULATION VALIDATION PERFORMANCE ANALYSIS OF FRANCIS TURBINE

Research and Analysis on Model Measurement and Prototype Operation of Large-Scale Kaplan Turbine

The Influence of Structure Optimization on Vortex Suppression and Energy Dissipation in the Draft Tube of Francis Turbine

Comprehensive Hydraulic Improvement and Parametric Analysis of a Francis Turbine Runner

Flow characteristic analysis under different runner-vane-match

Optimization design and test verification of guide vanes for a fish-friendly Francis turbine

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Testing and Numerical Analysis of Abnormal Pressure Pulsations in Francis Turbines

Experience for the Design of Hydraulic Turbine Type Choice from the Operating Conditions of Hydraulic Turbine in Wanjiazhai Hydropower Station

Investigation of the Internal Flow in a Francis Turbine for Comparing the Flow Noise of Different Operation Conditions

Study on the effects of runner geometric parameters on the performance of micro Francis turbines used in water supply system of high-rise buildings

Analytical Implementation and Prediction of Hydraulic Characteristics for a Francis Turbine Runner Operated at BEP

Experimental and Numerical Simulation Study on the Flow Characteristics of the Draft Tube in Francis Turbine