Abstract:A super high-head Francis turbine with a gross head of nearly 700 m was designed with computational fluid dynamics (CFD) simulation and laboratory tests. Reduced-scale (1:3.7) physical and numerical models of the real-scale prototype were created to investigate the hydraulic performance. According to the CFD analysis, a strong rotor–stator interaction (RSI) between guide vanes and runner blades is observed as a result of the high-speed tangential flow towards runner created by the super high water head as well as the small gaps between the radial blades. At the designed best efficiency point (BEP), there is no significant flow recirculation inside the flow passage and minor loss occurs at the trailing edge of the stay vanes and guide vanes. Maximum velocity is observed at runner inlets due to flow acceleration through the narrow passages between the guide vanes. The elbow-shaped draft tube gradually decreases the flow velocity to keep the kinetic energy loss at a minimum. The laboratory test was conducted on a reduced-scale physical model to investigate the pressure pulsations and guide vane torque (GVT) under variable-discharge configurations, which are key concerns in the design of a high head turbine. Pressure sensor networks were installed at the inlet pipe, vaneless space and draft tube, respectively. The most intense pressure variation occurs at the inlet pipe and elbow at 0.04–0.2 GVOBEP and 1.5–1.8 GVOBEP with a low frequency about 0.3 times of the runner frequency, while the vibration in vaneless zone performs stable with the blade passing frequency caused by RSI. The GVT shows a declining trend and then keeps stable as GVOs increases at synchronized condition. For the misaligned conditions, the torque of adjacent guide vanes differs a lot except at the synchronous angle and maximum absolute value at least doubles than the synchronized condition.

Optimization design and test verification of guide vanes for a fish-friendly Francis turbine

Numerical study of the influence of blade inlet design parameters on the internal flow characteristics and energy performance of a Francis turbine

Turbulent Simulation of Francis Turbine with 3D Guide Vanes

Evaluation of the prototype performance of Wanjiazhai Francis turbine with flow pattern analysis

Research on the Turbulent Flow around Guide Vane of Francis Turbine

Optimal Selection of Blade Number of Hydraulic Turbine Based on Computational Fluid Dynamics

Influence of 3D Guide Vanes on the Channel Vortices in the Runner of a Francis Turbine

Effects of Head and Discharge on Internal Flow Characteristics of a High-Quality Installed 1 GW Francis Turbine

Investigating the Performance of a Super High-head Francis Turbine under Variable Discharge Conditions Using Numerical and Experimental Approach

Turbulence simulation and experimental study on new 3D wicket gate of francis turbine

Study on influence of the construction change of the spiral casing and draft tube on the flow loss in low head Francis turbine

EXPERIMENTAL AND CFD SIMULATION VALIDATION PERFORMANCE ANALYSIS OF FRANCIS TURBINE

Effect of guide vane profile on the hydraulic performance of moderate low-specific-speed Francis turbine

The Influence of Structure Optimization on Vortex Suppression and Energy Dissipation in the Draft Tube of Francis Turbine

Flow characteristic analysis under different runner-vane-match

Experimental and Numerical Simulation Study on the Flow Characteristics of the Draft Tube in Francis Turbine

Optimization of Fish-Friendly Bulb Turbine Based on Orthogonal Method and Computational Fluid Dynamics

A CFD-Based Shape Design Optimization Process of Fixed Flow Passages in a Francis Hydro Turbine

Optimization of a Francis Turbine Through Flow Simulation with a RNG k-ω Turbulence Model

Numerical Investigation of Cavitation Improvement for A Francis Turbine

Comprehensive Hydraulic Improvement and Parametric Analysis of a Francis Turbine Runner