Abstract:Most machine elements, such as gears and bearings, are operated in the mixed lubrication region. To evaluate lubrication performance for these tribological components, a contact model in mixed elastohydrodynamic lubrication is presented. This model deals with the EHL problem in the very thin film region where the film is not thick enough to separate the asperity contact of rough surface. The macro contact area is then divided into the lubricated area and the micro asperity contact areas by the contacted rough surfaces. In the case when asperity to asperity contact is present, Reynolds equation is only valid in the lubricated areas. Asperity contact pressure is determined by the interaction of two mating surfaces. The applied load is carried out by the lubricant film and the contacted asperities. FFT techniques are utilized to calculate the surface displacement (forward problem) by convolution and the asperity contact pressure (inverse problem) by deconvolution for non-periodic surfaces. With the successful implementation of FFT and multigrid methods, the lubricated contact problem can be solved within hours on a PC for the grids as large as one million nodes. This capability enables us to simulate random rough surfaces in a dense mesh. The load ratio, contact area ratio and average gap are introduced to characterize the performance of mixed lubrication with asperity contacts. Discussions are given regarding the asperity orientation as well as the effect of rolling-sliding condition. Numerical results of real rough topography are illustrated with effects of velocity parameter on load ratio, contact ratio, and average gap.

A Deterministic Mixed Lubrication Model for Parallel Rough Surfaces Considering Wear Evolution

Modeling and simulation of wear for alignment mechanism of large aircraft component

Numerical Prediction of Surface Wear and Roughness Parameters During Running-In for Line Contacts under Mixed Lubrication

Investigation of Normal Dynamic Contact Stiffness and Damping Characteristics in Mixed Lubrication for Non-Gaussian Rough Surfaces

Understanding the Mechanism of Load-Carrying Capacity Between Parallel Rough Surfaces Through a Deterministic Mixed Lubrication Model

A lubricated wear model for determining wear surface geometry on journal-bearing surfaces

Evaluating the contact model for anisotropic non-Gaussian roughness in mixed lubrication regime

A New Deterministic Model for Mixed Lubricated Point Contact with High Accuracy

Simulation of Sliding Wear in Mixed Lubrication

A Mixed Elasto-Hydrodynamic Lubrication Model for Studying Tribological Properties of Rough Surfaces

A Dynamic Wear Model for Micro-Grooved Water-Lubricated Bearings under Transient Mixed Lubrication Condition

Abrasive Wear Model for Lubricated Sliding Contacts

Mixed Lubricated Line Contact Analysis for Spur Gears Using A Deterministic Model

Wear Simulations of Involute Harmonic Gear Under Mixed Lubrication Condition

Numerical Prediction of Wear Process of an Initial Line Contact in Mixed Lubrication Conditions

Research on Mixed Lubrication Problems of the Non-Gaussian Rough Textured Surface With the Influence of Stochastic Roughness in Consideration

A Mixed Elastohydrodynamic Lubrication Model With Asperity Contact

An Elastoplastic Contact Model Considering Wear Based on Digital Rough Surfaces in Spatial Domain

An Efficient Numerical Model for Predicting the Torsional Fretting Wear Considering Real Rough Surface

A Mixed Lubrication Model with Consideration of Starvation and Interasperity Cavitations

The Mixed Regime and Wear Mechanism of Elliptical Contact in the Start-Up Process Considering Interface Material Properties: A Theoretical Prediction