Abstract:Cylindrical gear with variable hyperbolic circular arc tooth trace (VH-CATT) is a new type of gear. Sliding wear is the main mode of the surface failure of multiple mechanical parts. Both the lubrication state and contact temperature considerably influence wear characteristics, which may aggravate the transmission performance of gear pairs. Wear, contact temperature, as well as lubrication states are jointly explored. Therefore, an integrated wear prediction model was proposed through taking into account flash contact temperature and surface roughness of VH-CATT cylindrical gears in mixed elastohydrodynamic lubrication. According to the equivalent ellipse contact model of VH-CATT cylindrical gears and tooth surface equation, normal curvature and velocity relations for VH-CATT cylindrical gears were observed, and the normal meshing force was obtained through the consideration of load sharing coefficients and quality grades. Flash contact temperature was estimated by using the literature. This study proposes analytical solutions for investigating how various surface roughness, operation, and geometric parameters affect asperity contact ratio (ACR), asperity contact pressure (ACP), flash contact temperature (FCT), as well as wear depth (WD) related to driving gears. ACR, ACP, FCT, as well as WD initially decrease and then increase from engaging-in to engaging-out processes. The minimum occurs at the pitch point. The WD declines as module, cutter radius, and rotational velocity increase while augmenting when surface roughness and torques increase. The maximum and minimum wear depths in driving gears occur at the dedendum and pitch point, respectively. Its overall wear is reduced by 23.16 % compared to the wear of spur gears. The results are valuable for the studies of tooth pitting, wear resistance, and fatigue life improvement for VH-CATT cylindrical gear. These studies can provide verification data and references required for engineering designs and VH-CATT cylindrical gear operations.

The Mixed Regime and Wear Mechanism of Elliptical Contact in the Start-Up Process Considering Interface Material Properties: A Theoretical Prediction

Modeling and simulation of wear for alignment mechanism of large aircraft component

Combined Effect of Boundary Layer Formation and Surface Smoothing on Friction and Wear Rate of Lubricated Point Contacts During Normal Running-in Processes

Numerical Prediction of Surface Wear and Roughness Parameters During Running-In for Line Contacts under Mixed Lubrication

Frictional Behaviour of Engineering Surfaces in Overall Lubrication Regimes of Point Contacts

Simulation of Sliding Wear in Mixed Lubrication

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact

Thermal mixed elastohydrodynamic lubrication modeling and analysis of the lubricated non-conformal contacts with non-Gaussian surface roughness and coating

Numerical Prediction of Wear Process of an Initial Line Contact in Mixed Lubrication Conditions

Effects of Texture Orientation on the Mixed Thermal Elastohydrodynamic Lubrication and Fatigue Life in Point Contacts

Modeling and simulation for wear prediction in planar mechanical systems with multiple clearance joints

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

A Fully Coupled Normal and Tangential Contact Model to Investigate the Effect of Surface Roughness on the Partial Slip of Dissimilar Elastic Materials

On Lubrication States after a Running-In Process in Aqueous Lubrication.

Transition of frictional states and surface roughness effects in lubricated contacts

Integrated wear prediction model for cylindrical gear with variable hyperbolic circular arc tooth trace under mixed elastohydrodynamic lubrication

Research on Mixed Lubrication Problems of the Non-Gaussian Rough Textured Surface With the Influence of Stochastic Roughness in Consideration

Finite element simulation and experimental test of the wear behavior for self-lubricating spherical plain bearings

Theoretical and Experimental Study of Transient Behavior of Spiral-Groove Thrust Bearings During Start-Up

Numerical Running-In Method for Modifying Cylindrical Roller Profile under Mixed Lubrication of Finite Line Contacts

Correlating numerical modelling with experimental studies to quantify the wear resistance of high-carbon chromium bearing steel in mixed lubrication