Abstract:This paper investigates Nonlinear Time-Varying Mixed Lubrication (NTVML) performances of a Coupled Spiral Microgroove Water-lubricated Bearing (CSMWB), which consists of both thrust and journal microgroove bearings, using a developed numerical model. A 5-degree-of-freedom (5-DOF) dynamic model of the CSMWB is fully coupled with a transient mixed lubrication model considering mass conservation cavitation. The validity of the present model is supported by the corresponding experimental evidences in terms of hydrodynamic load capacity and friction coefficient. Based on the model, the evolutions of the transient interfacial behaviors, such as hydrodynamic pressure, elastic-plastic contact pressure, cavitation distribution etc., under nonlinear external excitations are revealed, and the significant role of the mass conservation boundary condition on the NTVML performances in such bearings is highlighted. Subsequently, an extensive parametric study is performed to determine the optimal design of such bearings. Numerical results indicate that a relatively large spiral angle of the thrust bearing has potential to reduce the transient asperity contact for both the journal and thrust bearings. Moreover, a relatively small microgroove width ratio can improve the NTVML performance of journal bearing, while it increases the transient asperity contact of the spiral microgroove thrust bearing. Furthermore, this paper demonstrates the applicability of the CSMWB in rim-driven thrusters and provides the recommended parameters for the optimal performance.

Theoretical and Experimental Study of Transient Behavior of Spiral-Groove Thrust Bearings During Start-Up

Five-DOF nonlinear tribo-dynamic analysis for coupled bearings during start-up

Modelling and theoretical research on transient lubrication and wear coupling behavior of main bearing during start-up of low-speed diesel engine

Numerical analysis on the dynamic behavior of the water-lubricated bearing of the energy recovery turbocharger during start-up

Dynamic Mixed Lubrication Investigation of Water-Lubricated Bearing With Unbalanced Rotor During Start-Up

Transient Thermo-Elasto-hydrodynamic Analysis of a Bidirectional Thrust Bearing in Start-Up and Shutdown Processes

Transient mixed thermal elastohydrodynamic lubrication analysis of aero ball bearing under non-steady state conditions

Transient mixed-lubrication analysis of low-viscosity lubricated bearings under impact load with consideration of turbulence

Asymmetry Characteristic of Tilting-Pad Thrust Bearing During the Start-Up and Shut-Down Process

On the tribo-dynamic behaviors during start-up of water lubricated bearing considering imperfect journal

Transient dynamic analysis and experimental verification on lubrication regime transition during startup period of non-contacting mechanical seal in liquid oxygen turbopump

Transient mixed thermal elastohydrodynamic lubrication under startup and shut down conditions

On the nonlinear time-varying mixed lubrication for coupled spiral microgroove water-lubricated bearings with mass conservation cavitation

Influence of squeezing and interface slippage on the performance of water-lubricated tilting-pad thrust bearing during start-up and shutdown

Dynamic analysis of a high-speed micro compressor supported by spiral-grooved hydrodynamic air bearing

Experimental Study of the Transient Thermal Effect and the Oil Film Thickness of the Equalizing Thrust Bearing in the Process of Start-Stop with Load

Transient tribo-dynamic analysis of crosshead slipper in low-speed marine diesel engines during engine startup

Experimental and Numerical Studies of Cavitation Effects in A Tapered Land Thrust Bearing

Modeling and analysis of transient lubrication characteristic of the helicopter main transmission spiral bevel gears in point contacts

Direct Observation of Cavitation Phenomenon and Hydrodynamic Lubrication Analysis of Textured Surfaces

Numerical analysis of turbulence effect for coupled journal-thrust water-lubricated bearing with micro grooves