Abstract:Despite the fact that many tribological components are designed to operate with a comparatively thick film of lubricant, the bearing surfaces often still deteriorate with time as hard particulate contaminants are swept through the bearing gap. These may arise from the external environment or, perhaps, be wear debris from other pairs of surfaces lubricated by the same fluid. In order to investigate this phenomenon experimentally it is necessary to develop a predictable hydrodynamic film between the test surfaces which can be contaminated by small volumes of carefully graded abrasive particles. Here we describe the use of a foil bearing to generate such films between 10 and 50 μm thick to which contaminants such as powdered quartz or finely divided diamond can be added. As the ratio of the characteristic particle size to film thickness is varied not only do the wear rates of the solid surfaces change but examination of the wear tracks suggests that very different mechanisms of material loss come into operation. When the size ratio is low the worn surface of the cylinder is covered by what appears to be small erosion pits; these display virtually no alignment in the direction of relative sliding and it seems that the particles tumble and roll freely through the gap. Above some critical value of the ratio the appearance of the surface changes dramatically to a grooved or micro-machined surface with all the grooves aligned in the sliding direction. A relatively simple theoretical model is developed, based on what happens to a typical particle, which goes some way to explaining these observations. As well as being consistent with the observed transition from “tumbling” to “grooving”, the model can also explain why increasing the hardness differential between the hard and the soft surfaces does not always lead to a reduction in damage to the harder member of the pair.

Abrasive Wear Model for Lubricated Sliding Contacts

A lubricated wear model for determining wear surface geometry on journal-bearing surfaces

Simulation of Sliding Wear in Mixed Lubrication

A Deterministic Mixed Lubrication Model for Parallel Rough Surfaces Considering Wear Evolution

Prediction of Sliding Friction Force of Rough Surfaces in Lubricated Point Contacts

Wear model based on real-time surface roughness and its effect on lubrication regimes

Contact Analysis of Abrasive Wear

Numerical Prediction of Surface Wear and Roughness Parameters During Running-In for Line Contacts under Mixed Lubrication

A computer model for sliding friction in lubricated-point contacts

A Wear Model of Plane Sliding Pairs Based on Fatigue Contact Analysis of Asperities

A Novel Contact Model for Rough Surfaces Using Piecewise Linear Interpolation and Its Application in Gear Wear

Theoretical Study on Tribological Mechanism of Solid Lubricating Films in a Sand–Dust Environment

An Elastoplastic Contact Model Considering Wear Based on Digital Rough Surfaces in Spatial Domain

Numerical model of boundary lubrication under point contacts

Wear Analysis of Rolling Bearing Contact Surfaces Based on Finite Element Method

The Friction and Wear Model of Steels and Their Probable Statistic Calculations

A Dynamic Contact Model of Rough Surfaces Based on the Microscopic Contact Analysis of Asperities

Micropitting Fatigue Wear Simulation in Conformal-Contact under Mixed Elastohydrodynamic Lubrication

Mechanisms of abrasive wear in lubricated contacts

Effects of Surface Roughness on Sliding Friction in Lubricated-Point Contacts: Experimental and Numerical Studies

Experimental Analysis and Wear Prediction Model Based on Friction Heat for Dry Sliding Contact