Abstract:We propose capacitively driven low-swing global interconnect circuit using a receiver that utilizes magnetoelectric (ME) effect induced magnetization switching to reduce the energy consumption. Capacitively driven wire has recently been shown to be effective in improving the performance of global interconnects. Such techniques can reduce the signal swing in the interconnect by using a capacitive divider network and does not require an additional voltage supply. However, the large reduction in signal swing makes it necessary to use differential signaling and amplification for successful regeneration at the receiver, which add area and static power. ME effect induced magnetization reversal has recently been proposed which shows the possibility of using a low voltage to switch a nanomagnet adjacent to a multi-ferroic oxide. Here, we propose an ME effect based receiver that uses the low voltage at the receiving end of the global wire to switch a nanomagnet. The nanomagnet is also used as the free layer of a magnetic tunnel junction (MTJ), the resistance of which is tuned through the ME effect. This change in MTJ resistance is converted to full swing binary signals by using simple digital components. This process allows capacitive low swing interconnection without differential signaling or amplification, which leads to significant energy efficiency. Our simulation results indicate that for 5-10 mm long global wires in IBM 45 nm technology, capacitive ME design consumes 3x lower energy compared to full-swing CMOS design and 2x lower energy compared to differential amplifier based low-swing capacitive CMOS design.

Design Optimization for Capacitive-Resistively Driven On-Chip Global Interconnect

Two 10Gb/s/pin Low-Power Interconnect Methods for 3D ICs

Design Optimization For Ac Coupled On-Chip Global Interconnect

Advanced RF/baseband Interconnect Schemes for Inter- and Intra-Ulsi Communications

Transfer Functions of On-Chip Global Interconnects Based on Distributed RLCG Interconnects Model

Modeling and Characterization of On‐Chip Interconnects

A Coupling and Crosstalk Considered Timing-Driven Global Routing Algorithm for High Performance Circuit Design

RF-interconnect for multi-Gb/s digital interface based on 10 GHz RF-modulation in 0.18 /spl mu/m CMOS

Three-dimensional circuit integration based on self-synchronized RF-interconnect using capacitive coupling

Sub-THz Interconnect for Planar Chip-to-Chip Communications

Methods and designs for improving the signal integrity for 3D electrical interconnects in high performance IC packaging

Low-latency low-power scheme for on-chip global interconnects

Analysis and Optimization of Thermal-Driven Global Interconnects in Nanometer Design

A Global Wire Planning Scheme For Network-On-Chip

Simultaneous Wire Sizing And Decoupling Capacitance Budgeting For Robust On-Chip Power Delivery

Capacitively Driven Global Interconnect with Magnetoelectric Switching Based Receiver for Higher Energy Efficiency

Design and Optimization of Multi-core Fibers with Low Crosstalk and Large Effective Area

A Low-Latency and Low-Power Hybrid Insertion Methodology for Global Interconnects in VDSM Designs

Noise Analysis and Transmission Coding Optimization for High-speed Interconnection

Wafer-Area-Saving Test Structures and Measurement Method for the Characterization of Interconnect Resistance and Capacitance in Nanometer Technologies

System Level Interconnect Design for Network-on-chip Using Interconnect IPs.