Abstract:In this study, a high valued product submicronic ?-alumina was successfully extracted from aluminum slags generated by the local aluminum industry. The extraction technique was based on the leaching of slags by H2SO4 followed by precipitation. The coarser aluminum-rich fractions of the slags were used in this study instead of the finer oxide-rich fractions that were commonly used in previous studies. The precipitation of the leached slags by NH4OH was controlled by a zetameter in order to determine the optimal precipitation pH. Then, the obtained gel showing the higher precipitation rate and the finer particle size was calcined at 1200 ?C and characterized by the XRF, XRD, FTIR, SEM, EDS, and laser granulometry. Even without any pretreatment of slags, the XRF analysis revealed that a high purity and high extraction efficiency of 99.2% and 93.75% respectively could be achieved just at a leaching acid concentration of 15%. The XRD spectrum shows that the produced alumina was pure a-corundum, which was confirmed by the FTIR spectrum showing only the Al-O bonds. The laser granulometry showed that the recovered powder exhibited a wide particle size distribution, which was between 50 nm and 20 ?m, while the average particle size (d50) was about 400 nm. The SEM observations revealed that the grains were in the form of submicronic whiskers. The above characteristics allowed the obtained alumina powder in this study to be used in the usual applications of alumina such as refractory, ceramic fibers, abrasive, etc. The obtained powders may also assume applications as a thermally stable substitute for the commonly used transition alumina powders, which needs further investigations in future studies.

Method for Extracting Nanoscale Gamma-alumina by Oil Shale Ash

Preparation and Characterization of Nanosilica from Oil Shale Ash.

Synthesis of Nano-Alumina Hydroxide Sol Using Sol-gel Method

Study on Preparation and Characterization of gamma-Al(2)O(3) from Coal Fly Ash

Nano-sized amorphous alumina particles obtained by ball milling ZnO and Al powder mixture

Preparation and Characterization of Nanocrystalline Gamma-Al2o3 by Sol-Gel Process

Fabrication of Nano-Layer-structure Alumina Powders from an Alumina Concentrate Through an Intensified Bayer Process

Preparation of Large-Pore-Volume Gamma-Alumina Nanofibers with A Narrow Pore Size Distribution in A Membrane Dispersion Microreactor

Continuously Batched Preparation and Characterization of High-purity Nano α-Al2 O3

Synthesis of submicronic α-alumina from local aluminum slags

Facile synthesis of nano-crystalline alpha-alumina at low temperature via an absolute ethanol sol-gel strategy

Preparation and Characterization of Alumina-Zirconia Nanoparticles

Synthesis of Gamma-Alumina Nanopowders Using Waste Metal Aluminum and Stability Surfactants

Coprecipitation Synthesis of Large-Pore-Volume -Alumina Nanofibers by Two Serial Membrane Dispersion Microreactors with a Circulating Continuous Phase

Thermodynamics and kinetics of alumina extraction from fly ash using an ammonium hydrogen sulfate roasting method

Synthesis of nano α-alumina powders using hydrothermal and precipitation routes: a comparative study

Synthesis of γ-alumina via precipitation in ethanol

Ultrasound As a Tool to Synthesize Nano-Sized Silica–Alumina Catalysts with Controlled Mesoporous Distribution by a Novel Sol–Gel Process

Preparation of Alumina Ultrafine Powders Through Acrylamide, Starch and Glutaric Dialdehyde Mediated Sol–gel Method

Alumina Extraction from Alumina Rich Fly Ash Generated from Inner-Mongolia Chinese Coal

Size-controlled synthesis of nano α-alumina particles through the sol–gel method