Abstract:Different residues of Huadian oil shale processing were investigated. Their inorganic chemical composition and phase structural characteristics were identified by X-ray fluorescence spectrometry (XRF) and X-ray diffractometry (XRD). The influence of calcination conditions on processing residues at different ash activation degrees and impurities' leaching rates as well as the quality of obtained SiO2 concentrate were investigated by a single-factor method. The results showed that only circular crossflow-type retorting-derived semicoke has different phase-structural characteristics at different calcination temperatures. In the range of 700-800 degrees C, the leaching rate of aluminum and iron reaches the maximum. To prepare SiO2 concentrate, starting material should be calcined for 1.5 h at 700-800 degrees C. As a result, SiO2 concentrate which meets the national standard of silica white will be obtained; the content of SiO2 is 92.34% and its specific surface area 104 m(2)/g. Phase structures of Fushun-type retorting residue and cogeneration power plant ash did not change dramatically at different calcination temperatures. The leaching rate of Al and Fe reached the maximum. Further calcination is unnecessary in reutilization, only removal of impurities by means of acid soaker is relevant. Fushun-type retorting residue can also be used to make SiO2 concentrate which meets the national standard; the content of SiO2 is 90.38%, its specific surface area is 91 m(2)/g. The leaching rate of aluminum from cogeneration power plant ash is lower, and this ash cannot be used to prepare silica white meeting the national standard. It can be applied as an ingredient of cement, at brick preparation, etc. Separation and purification products are a mixture of crystalline SiO2 and amorphous SiO2, while the content of crystalline SiO2 is 32.2%.

Preparation and Characterization of Nanosilica from Oil Shale Ash.

Preparation and properties of silica nanoparticles from oil shale ash

Preparation of Nano-Sized Α-Al2o3 from Oil Shale Ash

Preparation and size control of nano-silica using acid leaching method by oil shale ash

Preparation and characterization of silica aerogels from oil shale ash

Preparation of Silica by Alkaline-Heating and Precipitation Method from Corn Straw Ash

Method for Extracting Nanoscale Gamma-alumina by Oil Shale Ash

Azeotropic distillation-assisted preparation of nanoscale gamma-alumina powder from waste oil shale ash

PREPARATION AND INFLUENCE ON PARTICLE SIZE OF SILICA USING RESIDUE OF OIL SHALE

Preparation of highly dispersed nanosilica from rice husk by aprecipitation method combined with high pressure homogenization

Characterization of Oil Shale Processing Residues and Separated Products

The preparation of silica white from fly ash and its characterization

Preparation of Silica Aerogel from Oil Shale Ash by Fluidized Bed Drying

Synthesis of Ultrafine Silica Powders Based on Oil Shale Ash by Fluidized Bed Drying of Wet-Gel Slurry

Hydrothermal synthesis of hierarchical micron flower-like γ-AlOOH and γ-Al 2 O 3 superstructures from oil shale ash

Study on preparation and surface modification of precipitated silica obtained from fly ash

TECHNIQUE OF PREPARING MODIFIED SILICA FROM OIL SHALE RESIDUE

Preparation of Precipitated Nano-silica from Acid Leaching Residue of Coal Ash by Carbonation Method

Synthesis of hydrophobic alumina aerogel with surface modification from oil shale ash

PREPARATION OF AMORPHOUS SILICA FROM OIL SHALE RESIDUE AND SURFACE MODIFICATION BY SILANE COUPLING AGENT

Preparation and Characterization of Nano-Sized SiO2 Particles by Microemulsion Method